@@ -2097,12 +2097,11 @@ usb_2_hsphy: phy@88e4000 {
};
usb_1_qmpphy: phy@88e9000 {
- compatible = "qcom,sm8250-qmp-usb3-phy";
+ compatible = "qcom,sm8250-qmp-usb3-dp-phy";
reg = <0 0x088e9000 0 0x200>,
- <0 0x088e8000 0 0x20>;
- reg-names = "reg-base", "dp_com";
+ <0 0x088e8000 0 0x40>,
+ <0 0x088ea000 0 0x200>;
status = "disabled";
- #clock-cells = <1>;
#address-cells = <2>;
#size-cells = <2>;
ranges;
@@ -2116,7 +2115,7 @@ usb_1_qmpphy: phy@88e9000 {
<&gcc GCC_USB3_PHY_PRIM_BCR>;
reset-names = "phy", "common";
- usb_1_ssphy: lanes@88e9200 {
+ usb_1_ssphy: usb3-phy@88e9200 {
reg = <0 0x088e9200 0 0x200>,
<0 0x088e9400 0 0x200>,
<0 0x088e9c00 0 0x400>,
@@ -2128,6 +2127,20 @@ usb_1_ssphy: lanes@88e9200 {
clock-names = "pipe0";
clock-output-names = "usb3_phy_pipe_clk_src";
};
+
+ dp_phy: dp-phy@88ea200 {
+ reg = <0 0x088ea200 0 0x200>,
+ <0 0x088ea400 0 0x200>,
+ <0 0x088eac00 0 0x400>,
+ <0 0x088ea600 0 0x200>,
+ <0 0x088ea800 0 0x200>,
+ <0 0x088eaa00 0 0x100>;
+ #phy-cells = <0>;
+ #clock-cells = <1>;
+ clocks = <&gcc GCC_USB3_PRIM_PHY_PIPE_CLK>;
+ clock-names = "pipe0";
+ clock-output-names = "usb3_phy_pipe_clk_src";
+ };
};
usb_2_qmpphy: phy@88eb000 {
USB1 QMP PHY is not just a USB3 PHY, but USB3+DP PHY. Change device tree nodes accordingly. Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org> --- arch/arm64/boot/dts/qcom/sm8250.dtsi | 23 ++++++++++++++++++----- 1 file changed, 18 insertions(+), 5 deletions(-)