@@ -354,7 +354,11 @@ vreg_l6f_2p85: ldo6 {
};
};
-&qupv3_id_1 {
+&gmu {
+ status = "okay";
+};
+
+&gpu {
status = "okay";
};
@@ -372,6 +376,10 @@ resin {
};
};
+&qupv3_id_1 {
+ status = "okay";
+};
+
&remoteproc_adsp {
status = "okay";
@@ -349,7 +349,11 @@ vreg_l6f_2p85: ldo6 {
};
};
-&qupv3_id_1 {
+&gmu {
+ status = "okay";
+};
+
+&gpu {
status = "okay";
};
@@ -367,6 +371,10 @@ resin {
};
};
+&qupv3_id_1 {
+ status = "okay";
+};
+
&remoteproc_adsp {
status = "okay";
firmware-name = "qcom/sm8150/adsp.mdt";
@@ -1082,6 +1082,8 @@ gpu: gpu@2c00000 {
qcom,gmu = <&gmu>;
+ status = "disabled";
+
zap-shader {
memory-region = <&gpu_mem>;
};
@@ -1149,6 +1151,8 @@ gmu: gmu@2c6a000 {
operating-points-v2 = <&gmu_opp_table>;
+ status = "disabled";
+
gmu_opp_table: opp-table {
compatible = "operating-points-v2";
@@ -1496,6 +1500,8 @@ remoteproc_mpss: remoteproc@4080000 {
qcom,smem-states = <&modem_smp2p_out 0>;
qcom,smem-state-names = "stop";
+ status = "disabled";
+
glink-edge {
interrupts = <GIC_SPI 449 IRQ_TYPE_EDGE_RISING>;
label = "modem";
Components that rely on proprietary (not to mention signed!) firmware should not be enabled by default, as lack of the aforementioned firmware could cause various issues, from random errors to straight-up failing to boot. Not enabling modem back on the HDK, as it uses a sa8150. Also fixed a sorting mistake in both boards' dt while at it. Signed-off-by: Konrad Dybcio <konrad.dybcio@somainline.org> --- arch/arm64/boot/dts/qcom/sm8150-hdk.dts | 10 +++++++++- arch/arm64/boot/dts/qcom/sm8150-mtp.dts | 10 +++++++++- arch/arm64/boot/dts/qcom/sm8150.dtsi | 6 ++++++ 3 files changed, 24 insertions(+), 2 deletions(-)