@@ -54,14 +54,24 @@ pon: pon@800 {
mode-bootloader = <0x2>;
mode-recovery = <0x1>;
- pwrkey {
+ pon_pwrkey: pwrkey {
compatible = "qcom,pm8941-pwrkey";
interrupts = <0x0 0x8 0 IRQ_TYPE_EDGE_BOTH>;
debounce = <15625>;
bias-pull-up;
linux,code = <KEY_POWER>;
+
+ status = "disabled";
};
+ pon_resin: resin {
+ compatible = "qcom,pm8941-resin";
+ interrupts = <0x0 0x8 1 IRQ_TYPE_EDGE_BOTH>;
+ debounce = <15625>;
+ bias-pull-up;
+
+ status = "disabled";
+ };
};
pm660_temp: temp-alarm@2400 {
@@ -215,14 +215,14 @@ &blsp2_uart1 {
/* HCI Bluetooth */
};
-&pon {
- volup {
- compatible = "qcom,pm8941-resin";
- interrupts = <0x0 0x8 1 IRQ_TYPE_EDGE_BOTH>;
- debounce = <15625>;
- bias-pull-up;
- linux,code = <KEY_VOLUMEUP>;
- };
+&pon_pwrkey {
+ status = "okay";
+};
+
+&pon_resin {
+ status = "okay";
+
+ linux,code = <KEY_VOLUMEUP>;
};
&qusb2phy {
It's not worth duplicating the same node over and over again, so let's keep the common bits in the pm660 DTSI, making only changing the status and keycode necessary. Also, disable RESIN/PWR by default just in case if there are devices that doesn't use them. Signed-off-by: Dang Huynh <danct12@riseup.net> --- arch/arm64/boot/dts/qcom/pm660.dtsi | 12 +++++++++++- .../boot/dts/qcom/sdm630-sony-xperia-nile.dtsi | 16 ++++++++-------- 2 files changed, 19 insertions(+), 9 deletions(-)