[2/2] phy: qcom-edp: drop regulator loads

Commit Message

Johan Hovold Aug. 3, 2022, 12:33 p.m. UTC

Drivers should not be specifying active-mode regulator loads unless
supporting an idle mode where the load is reduced during runtime.

This effectively reverts commit a4888b2005d1 ("phy: qcom-edp: add
regulator_set_load to edp phy")

Link: https://lore.kernel.org/r/[e-mail]
Signed-off-by: Johan Hovold <[e-mail]>
---
 drivers/phy/qualcomm/phy-qcom-edp.c | 12 ------------
 1 file changed, 12 deletions(-)

Patch

diff --git a/drivers/phy/qualcomm/phy-qcom-edp.c b/drivers/phy/qualcomm/phy-qcom-edp.c
index 7e3570789845..cacd32f6e0cc 100644
--- a/drivers/phy/qualcomm/phy-qcom-edp.c
+++ b/drivers/phy/qualcomm/phy-qcom-edp.c
@@ -639,18 +639,6 @@  static int qcom_edp_phy_probe(struct platform_device *pdev)
 	if (ret)
 		return ret;
 
-	ret = regulator_set_load(edp->supplies[0].consumer, 21800); /* 1.2 V vdda-phy */
-	if (ret) {
-		dev_err(dev, "failed to set load at %s\n", edp->supplies[0].supply);
-		return ret;
-	}
-
-	ret = regulator_set_load(edp->supplies[1].consumer, 36000); /* 0.9 V vdda-pll */
-	if (ret) {
-		dev_err(dev, "failed to set load at %s\n", edp->supplies[1].supply);
-		return ret;
-	}
-
 	ret = qcom_edp_clks_register(edp, pdev->dev.of_node);
 	if (ret)
 		return ret;