@@ -36,35 +36,13 @@
/* QPHY_PCS_STATUS bit */
#define PHYSTATUS BIT(6)
#define PHYSTATUS_4_20 BIT(7)
-/* QPHY_PCS_READY_STATUS & QPHY_COM_PCS_READY_STATUS bit */
+/* QPHY_COM_PCS_READY_STATUS bit */
#define PCS_READY BIT(0)
-/* QPHY_V3_DP_COM_RESET_OVRD_CTRL register bits */
-/* DP PHY soft reset */
-#define SW_DPPHY_RESET BIT(0)
-/* mux to select DP PHY reset control, 0:HW control, 1: software reset */
-#define SW_DPPHY_RESET_MUX BIT(1)
-/* USB3 PHY soft reset */
-#define SW_USB3PHY_RESET BIT(2)
-/* mux to select USB3 PHY reset control, 0:HW control, 1: software reset */
-#define SW_USB3PHY_RESET_MUX BIT(3)
-
-/* QPHY_V3_DP_COM_PHY_MODE_CTRL register bits */
-#define USB3_MODE BIT(0) /* enables USB3 mode */
-#define DP_MODE BIT(1) /* enables DP mode */
-
-/* QPHY_V3_PCS_MISC_CLAMP_ENABLE register bits */
-#define CLAMP_EN BIT(0) /* enables i/o clamp_n */
-
#define PHY_INIT_COMPLETE_TIMEOUT 10000
#define POWER_DOWN_DELAY_US_MIN 10
#define POWER_DOWN_DELAY_US_MAX 11
-#define MAX_PROP_NAME 32
-
-/* Define the assumed distance between lanes for underspecified device trees. */
-#define QMP_PHY_LEGACY_LANE_STRIDE 0x400
-
struct qmp_phy_init_tbl {
unsigned int offset;
unsigned int val;
@@ -112,11 +90,8 @@ enum qphy_reg_layout {
/* PCS registers */
QPHY_SW_RESET,
QPHY_START_CTRL,
- QPHY_PCS_READY_STATUS,
QPHY_PCS_STATUS,
QPHY_PCS_POWER_DOWN_CONTROL,
- /* PCS_MISC registers */
- QPHY_PCS_MISC_TYPEC_CTRL,
/* Keep last to ensure regs_layout arrays are properly initialized */
QPHY_LAYOUT_SIZE
};
Drop defines and enums that are unused since the QMP driver split. Signed-off-by: Johan Hovold <johan+linaro@kernel.org> --- .../phy/qualcomm/phy-qcom-qmp-pcie-msm8996.c | 27 +------------------ 1 file changed, 1 insertion(+), 26 deletions(-)