| Message ID | 20221028075405.124809-1-luca.weiss@fairphone.com (mailing list archive) |
|---|---|
| State | Accepted |
| Headers | show |
| Series | [v2,1/2] arm64: dts: qcom: pm6350: add temp sensor and thermal zone config | expand |
On Fri, 28 Oct 2022 09:54:04 +0200, Luca Weiss wrote: > Add temp-alarm device tree node and a default configuration for the > corresponding thermal zone for this PMIC. Temperatures are based on > downstream values, except for trip2 where 125°C is used instead of 145°C > due to limitations without a configured ADC. > > Applied, thanks! [1/2] arm64: dts: qcom: pm6350: add temp sensor and thermal zone config commit: 16c0c46f38183573de5361d278772cfed2090b1c [2/2] arm64: dts: qcom: pm6150l: add temp sensor and thermal zone config commit: ce1b5eb74b3ef042b1c797f04e8683e7cad34ae6 Best regards,
diff --git a/arch/arm64/boot/dts/qcom/pm6350.dtsi b/arch/arm64/boot/dts/qcom/pm6350.dtsi index ecf9b9919182..c9575cf0f518 100644 --- a/arch/arm64/boot/dts/qcom/pm6350.dtsi +++ b/arch/arm64/boot/dts/qcom/pm6350.dtsi @@ -5,6 +5,37 @@ #include <dt-bindings/spmi/spmi.h> +/ { + thermal-zones { + pm6350-thermal { + polling-delay-passive = <100>; + polling-delay = <0>; + + thermal-sensors = <&pm6350_temp>; + + trips { + trip0 { + temperature = <95000>; + hysteresis = <0>; + type = "passive"; + }; + + trip1 { + temperature = <115000>; + hysteresis = <0>; + type = "hot"; + }; + + trip2 { + temperature = <125000>; + hysteresis = <0>; + type = "critical"; + }; + }; + }; + }; +}; + &spmi_bus { pmic@0 { compatible = "qcom,pm6350", "qcom,spmi-pmic"; @@ -35,6 +66,13 @@ pm6350_resin: resin { }; }; + pm6350_temp: temp-alarm@2400 { + compatible = "qcom,spmi-temp-alarm"; + reg = <0x2400>; + interrupts = <0x0 0x24 0x0 IRQ_TYPE_EDGE_BOTH>; + #thermal-sensor-cells = <0>; + }; + pm6350_gpios: gpios@c000 { compatible = "qcom,pm6350-gpio", "qcom,spmi-gpio"; reg = <0xc000>;
Add temp-alarm device tree node and a default configuration for the corresponding thermal zone for this PMIC. Temperatures are based on downstream values, except for trip2 where 125°C is used instead of 145°C due to limitations without a configured ADC. Signed-off-by: Luca Weiss <luca.weiss@fairphone.com> --- Changes in v2: * Decrease trip2 temp to 125degC from 145degC after discussion with Matthias arch/arm64/boot/dts/qcom/pm6350.dtsi | 38 ++++++++++++++++++++++++++++ 1 file changed, 38 insertions(+)