@@ -485,27 +485,31 @@ remoteproc_cdsp: remoteproc@b00000 {
interrupt-names = "wdog", "fatal", "ready",
"handover", "stop-ack";
- clocks = <&xo_board>,
- <&gcc GCC_CDSP_CFG_AHB_CLK>,
- <&gcc GCC_CDSP_TBU_CLK>,
- <&gcc GCC_BIMC_CDSP_CLK>,
- <&turingcc TURING_WRAPPER_AON_CLK>,
- <&turingcc TURING_Q6SS_AHBS_AON_CLK>,
- <&turingcc TURING_Q6SS_AHBM_AON_CLK>,
- <&turingcc TURING_Q6SS_Q6_AXIM_CLK>;
- clock-names = "xo",
- "sway",
- "tbu",
- "bimc",
- "ahb_aon",
- "q6ss_slave",
- "q6ss_master",
- "q6_axim";
-
- resets = <&gcc GCC_CDSP_RESTART>;
- reset-names = "restart";
-
- qcom,halt-regs = <&tcsr 0x19004>;
+ clocks = <&xo_board>;
+ clock-names = "xo";
+
+ /*
+ * If the node was using the PIL binding, then include properties:
+ * clocks = <&xo_board>,
+ * <&gcc GCC_CDSP_CFG_AHB_CLK>,
+ * <&gcc GCC_CDSP_TBU_CLK>,
+ * <&gcc GCC_BIMC_CDSP_CLK>,
+ * <&turingcc TURING_WRAPPER_AON_CLK>,
+ * <&turingcc TURING_Q6SS_AHBS_AON_CLK>,
+ * <&turingcc TURING_Q6SS_AHBM_AON_CLK>,
+ * <&turingcc TURING_Q6SS_Q6_AXIM_CLK>;
+ * clock-names = "xo",
+ * "sway",
+ * "tbu",
+ * "bimc",
+ * "ahb_aon",
+ * "q6ss_slave",
+ * "q6ss_master",
+ * "q6_axim";
+ * resets = <&gcc GCC_CDSP_RESTART>;
+ * reset-names = "restart";
+ * qcom,halt-regs = <&tcsr 0x19004>;
+ */
memory-region = <&cdsp_fw_mem>;
The QCS404 CDSP remote processor can be brought to life using two different bindings: 1. qcom,qcs404-cdsp-pas - currently used in DTSI. 2. qcom,qcs404-cdsp-pil. Comment out the properties related to qcom,qcs404-cdsp-pil (qcom,halt-regs, resets and additional clocks), to silence DT schema warnings. Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org> --- Changes since v2: 1. New patch. --- arch/arm64/boot/dts/qcom/qcs404.dtsi | 46 +++++++++++++++------------- 1 file changed, 25 insertions(+), 21 deletions(-)