@@ -623,6 +623,18 @@ cpu7_opp_3014mhz: opp-3014400000 {
};
};
+ eud_typec: connector {
+ compatible = "usb-c-connector";
+
+ ports {
+ port@0 {
+ con_eud: endpoint {
+ remote-endpoint = <&eud_con>;
+ };
+ };
+ };
+ };
+
memory@80000000 {
device_type = "memory";
/* We expect the bootloader to fill in the size */
@@ -3411,6 +3423,7 @@ usb_2_dwc3: usb@8c00000 {
phy-names = "usb2-phy";
maximum-speed = "high-speed";
usb-role-switch;
+
port {
usb2_role_switch: endpoint {
remote-endpoint = <&eud_ep>;
@@ -3585,17 +3598,23 @@ system-cache-controller@9200000 {
};
eud: eud@88e0000 {
- compatible = "qcom,sc7280-eud","qcom,eud";
+ compatible = "qcom,sc7280-eud", "qcom,eud";
reg = <0 0x88e0000 0 0x2000>,
<0 0x88e2000 0 0x1000>;
interrupts-extended = <&pdc 11 IRQ_TYPE_LEVEL_HIGH>;
+
ports {
+ #address-cells = <1>;
+ #size-cells = <0>;
port@0 {
+ reg = <0>;
eud_ep: endpoint {
remote-endpoint = <&usb2_role_switch>;
};
};
+
port@1 {
+ reg = <1>;
eud_con: endpoint {
remote-endpoint = <&con_eud>;
};
@@ -3603,17 +3622,6 @@ eud_con: endpoint {
};
};
- eud_typec: connector {
- compatible = "usb-c-connector";
- ports {
- port@0 {
- con_eud: endpoint {
- remote-endpoint = <&eud_con>;
- };
- };
- };
- };
-
nsp_noc: interconnect@a0c0000 {
reg = <0 0x0a0c0000 0 0x10000>;
compatible = "qcom,sc7280-nsp-noc";
As noted by Konrad while reviewing [1], fix the EUD and DWC3 node syntax in sc7280 dtsi file. While at it also fix the errors reported by '$ make dtbs_check' for the EUD node: arch/arm64/boot/dts/qcom/sc7280-crd-r3.dtb: eud@88e0000: ports: 'oneOf' conditional failed, one must be fixed: 'port' is a required property '#address-cells' is a required property '#size-cells' is a required property From schema: Documentation/devicetree/bindings/soc/qcom/qcom,eud.yaml [1]. https://lore.kernel.org/linux-arm-msm/20221231131945.3286639-1-bhupesh.sharma@linaro.org Signed-off-by: Bhupesh Sharma <bhupesh.sharma@linaro.org> --- arch/arm64/boot/dts/qcom/sc7280.dtsi | 32 +++++++++++++++++----------- 1 file changed, 20 insertions(+), 12 deletions(-)