@@ -114,7 +114,7 @@ enum adc5_cal_val {
* that is an average of multiple measurements.
* @scale_fn_type: Represents the scaling function to convert voltage
* physical units desired by the client for the channel.
- * @datasheet_name: Channel name used in device tree.
+ * @channel_name: Channel name used in device tree.
*/
struct adc5_channel_prop {
unsigned int channel;
@@ -126,7 +126,7 @@ struct adc5_channel_prop {
unsigned int hw_settle_time;
unsigned int avg_samples;
enum vadc_scale_fn_type scale_fn_type;
- const char *datasheet_name;
+ const char *channel_name;
};
/**
@@ -663,7 +663,7 @@ static int adc5_get_fw_channel_data(struct adc5_chip *adc,
if (ret)
channel_name = name;
- prop->datasheet_name = channel_name;
+ prop->channel_name = channel_name;
ret = fwnode_property_read_u32(fwnode, "qcom,decimation", &value);
if (!ret) {
@@ -853,8 +853,8 @@ static int adc5_get_fw_data(struct adc5_chip *adc)
adc_chan = &adc->data->adc_chans[prop.channel];
iio_chan->channel = prop.channel;
- iio_chan->datasheet_name = prop.datasheet_name;
- iio_chan->extend_name = prop.datasheet_name;
+ iio_chan->datasheet_name = adc_chan->datasheet_name;
+ iio_chan->extend_name = prop.channel_name;
iio_chan->info_mask_separate = adc_chan->info_mask;
iio_chan->type = adc_chan->type;
iio_chan->address = index;
iio_chan_spec::datasheet_name expects a channel/pin name on the hardware part, i.e. from its datasheet, instead of a friendly name from DT which typically describes the use of said channel. GPIO channels are commonly specialized in QCOM board DTS based on what a - typically thermistor - is connected to. Also rename adc5_channel_prop::datasheet_name to channel_name to that effect. Signed-off-by: Marijn Suijten <marijn.suijten@somainline.org> --- drivers/iio/adc/qcom-spmi-adc5.c | 10 +++++----- 1 file changed, 5 insertions(+), 5 deletions(-)