@@ -3,6 +3,7 @@
#include <dt-bindings/interrupt-controller/arm-gic.h>
#include <dt-bindings/clock/qcom,gcc-msm8960.h>
+#include <dt-bindings/reset/qcom,gcc-msm8960.h>
#include <dt-bindings/clock/qcom,lcc-msm8960.h>
#include <dt-bindings/mfd/qcom-rpm.h>
#include <dt-bindings/soc/qcom,gsbi.h>
@@ -71,7 +72,7 @@ pxo_board: pxo_board {
clock-output-names = "pxo_board";
};
- sleep_clk {
+ sleep_clk: sleep_clk {
compatible = "fixed-clock";
#clock-cells = <0>;
clock-frequency = <32768>;
@@ -370,5 +371,36 @@ gsbi1_spi: spi@16080000 {
status = "disabled";
};
};
+
+ usb1: usb@12500000 {
+ compatible = "qcom,ci-hdrc";
+ reg = <0x12500000 0x200>,
+ <0x12500200 0x200>;
+ interrupts = <GIC_SPI 100 IRQ_TYPE_LEVEL_HIGH>;
+ clocks = <&gcc USB_HS1_XCVR_CLK>, <&gcc USB_HS1_H_CLK>;
+ clock-names = "core", "iface";
+ assigned-clocks = <&gcc USB_HS1_XCVR_CLK>;
+ assigned-clock-rates = <60000000>;
+ resets = <&gcc USB_HS1_RESET>;
+ reset-names = "core";
+ phy_type = "ulpi";
+ ahb-burst-config = <0>;
+ phys = <&usb_hs1_phy>;
+ phy-names = "usb-phy";
+ #reset-cells = <1>;
+ status = "disabled";
+
+ ulpi {
+ usb_hs1_phy: phy {
+ compatible = "qcom,usb-hs-phy-msm8960",
+ "qcom,usb-hs-phy";
+ clocks = <&sleep_clk>, <&cxo_board>;
+ clock-names = "sleep", "ref";
+ resets = <&usb1 0>;
+ reset-names = "por";
+ #phy-cells = <0>;
+ };
+ };
+ };
};
};
Add the required nodes to support USB on the MSM8960 SoC. As it's very similar to the APQ8064 SoC, the nodes are almost identical Add a label to sleep_clk for the USB node to reference Signed-off-by: Rudraksha Gupta <guptarud@gmail.com> --- arch/arm/boot/dts/qcom-msm8960.dtsi | 34 ++++++++++++++++++++++++++++- 1 file changed, 33 insertions(+), 1 deletion(-)