diff mbox series

[v2,17/21] ARM: dts: qcom: ipq8064: Add PCIe bridge node

Message ID 20240321-pcie-qcom-bridge-dts-v2-17-1eb790c53e43@linaro.org (mailing list archive)
State Accepted
Commit 0c4d19b125401957123989a25094972cf0e77670
Headers show
Series Add PCIe bridge node in DT for Qcom SoCs | expand

Commit Message

Manivannan Sadhasivam March 21, 2024, 11:16 a.m. UTC 
On Qcom SoCs, the PCIe host bridge is connected to a single PCIe bridge
for each controller instance. Hence, add a node to represent the bridge.

Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org>
---
 arch/arm/boot/dts/qcom/qcom-ipq8064.dtsi | 30 ++++++++++++++++++++++++++++++
 1 file changed, 30 insertions(+)
diff mbox series

Patch

diff --git a/arch/arm/boot/dts/qcom/qcom-ipq8064.dtsi b/arch/arm/boot/dts/qcom/qcom-ipq8064.dtsi
index 2eb6758b6a3a..f128510d8445 100644
--- a/arch/arm/boot/dts/qcom/qcom-ipq8064.dtsi
+++ b/arch/arm/boot/dts/qcom/qcom-ipq8064.dtsi
@@ -1121,6 +1121,16 @@  pcie0: pcie@1b500000 {
 
 			status = "disabled";
 			perst-gpios = <&qcom_pinmux 3 GPIO_ACTIVE_LOW>;
+
+			pcie@0 {
+				device_type = "pci";
+				reg = <0x0 0x0 0x0 0x0 0x0>;
+				bus-range = <0x01 0xff>;
+
+				#address-cells = <3>;
+				#size-cells = <2>;
+				ranges;
+			};
 		};
 
 		pcie1: pcie@1b700000 {
@@ -1172,6 +1182,16 @@  pcie1: pcie@1b700000 {
 
 			status = "disabled";
 			perst-gpios = <&qcom_pinmux 48 GPIO_ACTIVE_LOW>;
+
+			pcie@0 {
+				device_type = "pci";
+				reg = <0x0 0x0 0x0 0x0 0x0>;
+				bus-range = <0x01 0xff>;
+
+				#address-cells = <3>;
+				#size-cells = <2>;
+				ranges;
+			};
 		};
 
 		pcie2: pcie@1b900000 {
@@ -1223,6 +1243,16 @@  pcie2: pcie@1b900000 {
 
 			status = "disabled";
 			perst-gpios = <&qcom_pinmux 63 GPIO_ACTIVE_LOW>;
+
+			pcie@0 {
+				device_type = "pci";
+				reg = <0x0 0x0 0x0 0x0 0x0>;
+				bus-range = <0x01 0xff>;
+
+				#address-cells = <3>;
+				#size-cells = <2>;
+				ranges;
+			};
 		};
 
 		qsgmii_csr: syscon@1bb00000 {