diff mbox series

[v2,06/21] arm64: dts: qcom: sm8550: Add PCIe bridge node

Message ID 20240321-pcie-qcom-bridge-dts-v2-6-1eb790c53e43@linaro.org (mailing list archive)
State Accepted
Commit cc2ad77882fb9ff54d9f626df73057558dcd8322
Headers show
Series Add PCIe bridge node in DT for Qcom SoCs | expand

Commit Message

Manivannan Sadhasivam March 21, 2024, 11:16 a.m. UTC 
On Qcom SoCs, the PCIe host bridge is connected to a single PCIe bridge
for each controller instance. Hence, add a node to represent the bridge.

Reviewed-by: Neil Armstrong <neil.armstrong@linaro.org>
Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org>
---
 arch/arm64/boot/dts/qcom/sm8550.dtsi | 20 ++++++++++++++++++++
 1 file changed, 20 insertions(+)
diff mbox series

Patch

diff --git a/arch/arm64/boot/dts/qcom/sm8550.dtsi b/arch/arm64/boot/dts/qcom/sm8550.dtsi
index 3904348075f6..760b6a6cb59c 100644
--- a/arch/arm64/boot/dts/qcom/sm8550.dtsi
+++ b/arch/arm64/boot/dts/qcom/sm8550.dtsi
@@ -1770,6 +1770,16 @@  pcie0: pcie@1c00000 {
 			phy-names = "pciephy";
 
 			status = "disabled";
+
+			pcie@0 {
+				device_type = "pci";
+				reg = <0x0 0x0 0x0 0x0 0x0>;
+				bus-range = <0x01 0xff>;
+
+				#address-cells = <3>;
+				#size-cells = <2>;
+				ranges;
+			};
 		};
 
 		pcie0_phy: phy@1c06000 {
@@ -1883,6 +1893,16 @@  pcie1: pcie@1c08000 {
 			phy-names = "pciephy";
 
 			status = "disabled";
+
+			pcie@0 {
+				device_type = "pci";
+				reg = <0x0 0x0 0x0 0x0 0x0>;
+				bus-range = <0x01 0xff>;
+
+				#address-cells = <3>;
+				#size-cells = <2>;
+				ranges;
+			};
 		};
 
 		pcie1_phy: phy@1c0e000 {