@@ -41,6 +41,7 @@
#define PLL_USER_CTL(p) ((p)->offset + (p)->regs[PLL_OFF_USER_CTL])
# define PLL_POST_DIV_SHIFT 8
# define PLL_POST_DIV_MASK(p) GENMASK((p)->width - 1, 0)
+# define PLL_ALPHA_MSB BIT(15)
# define PLL_ALPHA_EN BIT(24)
# define PLL_ALPHA_MODE BIT(25)
# define PLL_VCO_SHIFT 20
@@ -2117,6 +2118,18 @@ static void clk_zonda_pll_disable(struct clk_hw *hw)
regmap_write(regmap, PLL_OPMODE(pll), 0x0);
}
+static void zonda_pll_adjust_l_val(unsigned long rate, unsigned long prate, u32 *l)
+{
+ u64 remainder, quotient;
+
+ quotient = rate;
+ remainder = do_div(quotient, prate);
+ *l = quotient;
+
+ if ((remainder * 2) / prate)
+ *l = *l + 1;
+}
+
static int clk_zonda_pll_set_rate(struct clk_hw *hw, unsigned long rate,
unsigned long prate)
{
@@ -2133,6 +2146,9 @@ static int clk_zonda_pll_set_rate(struct clk_hw *hw, unsigned long rate,
if (ret < 0)
return ret;
+ if (a & PLL_ALPHA_MSB)
+ zonda_pll_adjust_l_val(rate, prate, &l);
+
regmap_write(pll->clkr.regmap, PLL_ALPHA_VAL(pll), a);
regmap_write(pll->clkr.regmap, PLL_L_VAL(pll), l);
The Zonda PLL has a 16 bit signed alpha and in the cases where the alpha value is greater than 0.5, the L value needs to be adjusted accordingly. Thus update the logic to handle the signed alpha val. Fixes: f21b6bfecc27 ("clk: qcom: clk-alpha-pll: add support for zonda pll") Cc: stable@vger.kernel.org Signed-off-by: Satya Priya Kakitapalli <quic_skakitap@quicinc.com> --- drivers/clk/qcom/clk-alpha-pll.c | 16 ++++++++++++++++ 1 file changed, 16 insertions(+)