@@ -422,7 +422,7 @@ static irqreturn_t pm860x_batt_handler(int irq, void *data)
info->temp_type = PM860X_TEMP_TINT;
}
mutex_unlock(&info->lock);
- /* clear ccnt since battery is attached or dettached */
+ /* clear ccnt since battery is attached or detached */
clear_ccnt(info, &ccnt_data);
return IRQ_HANDLED;
}
@@ -566,7 +566,7 @@ static int measure_temp(struct pm860x_battery_info *info, int *data)
ret = measure_12bit_voltage(info, PM8607_GPADC1_MEAS1, data);
if (ret)
return ret;
- /* meausered Vtbat(mV) / Ibias_current(11uA)*/
+ /* measured Vtbat(mV) / Ibias_current(11uA)*/
*data = (*data * 1000) / GPBIAS2_GPADC1_UA;
if (*data > TBAT_NEG_25D) {
@@ -283,7 +283,7 @@ static void ab8500_btemp_periodic_work(struct work_struct *work)
dev_warn(di->dev, "failed to identify the battery\n");
}
- /* Failover if a reading is erroneous, use last meausurement */
+ /* Failover if a reading is erroneous, use last measurement */
ret = thermal_zone_get_temp(di->tz, &bat_temp);
if (ret) {
dev_err(di->dev, "error reading temperature\n");
@@ -221,7 +221,7 @@ static bool is_charging(struct charger_manager *cm)
/* If at least one of the charger is charging, return yes */
for (i = 0; cm->desc->psy_charger_stat[i]; i++) {
- /* 1. The charger sholuld not be DISABLED */
+ /* 1. The charger should not be DISABLED */
if (cm->emergency_stop)
continue;
if (!cm->charger_enabled)
@@ -269,7 +269,7 @@ static void da9030_charger_check_state(struct da9030_charger *charger)
}
if (charger->adc.vchmax_res > charger->thresholds.vcharge_max ||
charger->adc.vchmin_res < charger->thresholds.vcharge_min ||
- /* Tempreture readings are negative */
+ /* Temperature readings are negative */
charger->adc.tbat_res < charger->thresholds.tbat_high ||
charger->adc.tbat_res > charger->thresholds.tbat_low) {
/* disable charger */
@@ -470,7 +470,7 @@ static int da9030_battery_charger_init(struct da9030_charger *charger)
if (ret)
return ret;
- /* enable auto ADC measuremnts */
+ /* enable auto ADC measurements */
return da903x_write(charger->master, DA9030_ADC_AUTO_CONTROL,
DA9030_ADC_TBAT_ENABLE | DA9030_ADC_VBAT_IN_TXON |
DA9030_ADC_VCH_ENABLE | DA9030_ADC_ICH_ENABLE |
@@ -73,7 +73,7 @@ struct max8925_power_info {
unsigned usb_online:1;
unsigned bat_online:1;
unsigned chg_mode:2;
- unsigned batt_detect:1; /* detecing MB by ID pin */
+ unsigned batt_detect:1; /* detecting MB by ID pin */
unsigned topoff_threshold:2;
unsigned fast_charge:3;
unsigned no_temp_support:1;
@@ -151,7 +151,7 @@ struct qcom_battmgr_message {
__le32 capacity_low;
__le32 capacity_warning;
__le32 cycle_count;
- /* thousandth of persent */
+ /* thousandth of percent */
__le32 accuracy;
__le32 max_sample_time_ms;
__le32 min_sample_time_ms;
@@ -832,7 +832,7 @@ static const struct smb2_register smb2_init_seq[] = {
AUTO_RECHG_BIT | EN_ANALOG_DROP_IN_VBATT_BIT |
CHARGER_INHIBIT_BIT,
.val = CHARGER_INHIBIT_BIT },
- /* STAT pin software override, match downstream. Parallell charging? */
+ /* STAT pin software override, match downstream. Parallel charging? */
{ .addr = STAT_CFG,
.mask = STAT_SW_OVERRIDE_CFG_BIT,
.val = STAT_SW_OVERRIDE_CFG_BIT },
Fixed some spelling errors, the details are as follows: -in the code comments: dettached->detached meausered->measured meausurement->measurement sholuld->should Tempreture->Temperature measuremnts->measurements detecing->detecting persent->percent Parallell->Parallel Signed-off-by: Shen Lichuan <shenlichuan@vivo.com> --- drivers/power/supply/88pm860x_battery.c | 4 ++-- drivers/power/supply/ab8500_btemp.c | 2 +- drivers/power/supply/charger-manager.c | 2 +- drivers/power/supply/da9030_battery.c | 4 ++-- drivers/power/supply/max8925_power.c | 2 +- drivers/power/supply/qcom_battmgr.c | 2 +- drivers/power/supply/qcom_pmi8998_charger.c | 2 +- 7 files changed, 9 insertions(+), 9 deletions(-)