@@ -151,7 +151,7 @@ static int is_intel_ider(struct pci_dev *dev)
}
/**
- * ata_generic_init - attach generic IDE
+ * ata_generic_init_one - attach generic IDE
* @dev: PCI device found
* @id: match entry
*
@@ -476,7 +476,7 @@ static int ata_dev_get_GTF(struct ata_device *dev, struct ata_acpi_gtf **gtf)
}
/**
- * ata_acpi_gtm_xfermode - determine xfermode from GTM parameter
+ * ata_acpi_gtm_xfermask - determine xfermode from GTM parameter
* @dev: target device
* @gtm: GTM parameter to use
*
@@ -624,6 +624,7 @@ static int ata_acpi_filter_tf(struct ata_device *dev,
* ata_acpi_run_tf - send taskfile registers to host controller
* @dev: target ATA device
* @gtf: raw ATA taskfile register set (0x1f1 - 0x1f7)
+ * @prev_gtf: previous taskfile register set
*
* Outputs ATA taskfile to standard ATA host controller.
* Writes the control, feature, nsect, lbal, lbam, and lbah registers.
@@ -62,7 +62,7 @@ static unsigned int sata_pmp_read(struct ata_link *link, int reg, u32 *r_val)
* sata_pmp_write - write PMP register
* @link: link to write PMP register for
* @reg: register to write
- * @r_val: value to write
+ * @val: value to write
*
* Write PMP register.
*
@@ -1067,7 +1067,7 @@ int ata_scsi_change_queue_depth(struct scsi_device *sdev, int queue_depth)
EXPORT_SYMBOL_GPL(ata_scsi_change_queue_depth);
/**
- * port_alloc - Allocate port for a SAS attached SATA device
+ * ata_sas_port_alloc - Allocate port for a SAS attached SATA device
* @host: ATA host container for all SAS ports
* @port_info: Information from low-level host driver
* @shost: SCSI host that the scsi device is attached to
@@ -1127,7 +1127,7 @@ int ata_sas_port_start(struct ata_port *ap)
EXPORT_SYMBOL_GPL(ata_sas_port_start);
/**
- * ata_port_stop - Undo ata_sas_port_start()
+ * ata_sas_port_stop - Undo ata_sas_port_start()
* @ap: Port to shut down
*
* May be used as the port_stop() entry in ata_port_operations.
@@ -250,7 +250,7 @@ static int ata_tport_match(struct attribute_container *cont,
/**
* ata_tport_delete -- remove ATA PORT
- * @port: ATA PORT to remove
+ * @ap: ATA PORT to remove
*
* Removes the specified ATA PORT. Remove the associated link as well.
*/
@@ -376,7 +376,7 @@ static int ata_tlink_match(struct attribute_container *cont,
/**
* ata_tlink_delete -- remove ATA LINK
- * @port: ATA LINK to remove
+ * @link: ATA LINK to remove
*
* Removes the specified ATA LINK. remove associated ATA device(s) as well.
*/
@@ -632,7 +632,7 @@ static void ata_tdev_free(struct ata_device *dev)
/**
* ata_tdev_delete -- remove ATA device
- * @port: ATA PORT to remove
+ * @ata_dev: ATA PORT to remove
*
* Removes the specified ATA device.
*/
@@ -28,7 +28,7 @@ struct pata_acpi {
/**
* pacpi_pre_reset - check for 40/80 pin
- * @ap: Port
+ * @link: Port
* @deadline: deadline jiffies for the operation
*
* Perform the PATA port setup we need.
@@ -63,8 +63,8 @@ static int pacpi_cable_detect(struct ata_port *ap)
/**
* pacpi_discover_modes - filter non ACPI modes
+ * @ap: ATA interface
* @adev: ATA device
- * @mask: proposed modes
*
* Try the modes available and see which ones the ACPI method will
* set up sensibly. From this we get a mask of ACPI modes we can use
@@ -224,7 +224,7 @@ static struct ata_port_operations pacpi_ops = {
/**
* pacpi_init_one - Register ACPI ATA PCI device with kernel services
* @pdev: PCI device to register
- * @ent: Entry in pacpi_pci_tbl matching with @pdev
+ * @id: PCI device ID
*
* Called from kernel PCI layer.
*
@@ -110,7 +110,7 @@ static struct ata_port_operations marvell_ops = {
/**
* marvell_init_one - Register Marvell ATA PCI device with kernel services
* @pdev: PCI device to register
- * @ent: Entry in marvell_pci_tbl matching with @pdev
+ * @id: Entry in marvell_pci_tbl matching with @pdev
*
* Called from kernel PCI layer.
*
Fix the kernel-doc warnings that are reported when building the ATA code with W=1. This patch only modifies source code comments. Signed-off-by: Bart Van Assche <bvanassche@acm.org> --- drivers/ata/ata_generic.c | 2 +- drivers/ata/libata-acpi.c | 3 ++- drivers/ata/libata-pmp.c | 2 +- drivers/ata/libata-sata.c | 4 ++-- drivers/ata/libata-transport.c | 6 +++--- drivers/ata/pata_acpi.c | 6 +++--- drivers/ata/pata_marvell.c | 2 +- 7 files changed, 13 insertions(+), 12 deletions(-)