diff mbox series

[v3,09/14] scsi_debug: Support the block limits extension VPD page

Message ID 20231017204739.3409052-10-bvanassche@acm.org (mailing list archive)
State New, archived
Headers show
Series Pass data temperature information to SCSI disk devices | expand

Commit Message

Bart Van Assche Oct. 17, 2023, 8:47 p.m. UTC
From SBC-5 r05:

"Reduced stream control:
a) reduces the maximum number of streams that the device server supports;
   and
b) increases the number of write commands that are able to specify a stream
   to be written in any write command that contains the GROUP NUMBER field
   in its CDB.

If the RSCS bit (see 6.6.5) is set to one, then the device server shall:
a) support per group stream identifier usage as described in 4.32.2;
b) support the IO Advice Hints Grouping mode page (see 6.5.7); and
c) set the MAXIMUM NUMBER OF STREAMS field (see 6.6.5) to a value that is
   less than 64.

Device servers that set the RSCS bit to one may support other features
(e.g., permanent streams (see 4.32.4)).

4.32.4 Permanent streams

A permanent stream is a stream for which the device server does not allow
closing or otherwise modifying the configuration of that stream. The PERM
bit (see 5.9.2.3) indicates whether a stream is a permanent stream. If a
STREAM CONTROL command (see 5.32) specifies the closing of a permanent
stream, the device server terminates that command with CHECK CONDITION
status instead of closing the specified stream. A permanent stream is always
an open stream. Device severs should assign the lowest numbered stream
identifiers to permanent streams."

Report that reduced stream control is supported.

Cc: Martin K. Petersen <martin.petersen@oracle.com>
Cc: Douglas Gilbert <dgilbert@interlog.com>
Signed-off-by: Bart Van Assche <bvanassche@acm.org>
---
 drivers/scsi/scsi_debug.c | 4 ++++
 1 file changed, 4 insertions(+)
diff mbox series

Patch

diff --git a/drivers/scsi/scsi_debug.c b/drivers/scsi/scsi_debug.c
index 46eaa2f9e63b..88cba9374166 100644
--- a/drivers/scsi/scsi_debug.c
+++ b/drivers/scsi/scsi_debug.c
@@ -1627,6 +1627,7 @@  static int resp_inquiry(struct scsi_cmnd *scp, struct sdebug_dev_info *devip)
 					arr[n++] = 0xb2;  /* LB Provisioning */
 				if (is_zbc)
 					arr[n++] = 0xb6;  /* ZB dev. char. */
+				arr[n++] = 0xb7;  /* Block limits extension */
 			}
 			arr[3] = n - 4;	  /* number of supported VPD pages */
 		} else if (0x80 == cmd[2]) { /* unit serial number */
@@ -1669,6 +1670,9 @@  static int resp_inquiry(struct scsi_cmnd *scp, struct sdebug_dev_info *devip)
 			arr[3] = inquiry_vpd_b2(&arr[4]);
 		} else if (is_zbc && cmd[2] == 0xb6) { /* ZB dev. charact. */
 			arr[3] = inquiry_vpd_b6(devip, &arr[4]);
+		} else if (cmd[2] == 0xb7) { /* block limits extension page */
+			arr[3] = 2; /* page length */
+			arr[5] = 1; /* Reduced stream control support (RSCS) */
 		} else {
 			mk_sense_invalid_fld(scp, SDEB_IN_CDB, 2, -1);
 			kfree(arr);