mbox series

[v2,0/2] spi: samsung: Add Exynos850 support

Message ID 20240125013543.31067-1-semen.protsenko@linaro.org (mailing list archive)
Headers show
Series spi: samsung: Add Exynos850 support | expand

Message

Sam Protsenko Jan. 25, 2024, 1:35 a.m. UTC 
Enable SPI support for Exynos850 SoC in spi-s3c64xx driver, and add the
corresponding bindings. It was tested using `spidev_test' tool in all
possible modes:

  - Polling mode: xfer_size <= 32
  - IRQ mode: 64 >= xfer_size >= 32
  - DMA mode: xfer_size > 64

with 200 kHz ... 49.9 MHz SPI frequencies. The next 3 approaches were
used:

  1. Software loopback ('-l' option for `spidev_test' tool)
  2. Hardware loopback (by connecting MISO line to MOSI)
  3. By communicating with ATMega found on Sensors Mezzanine board [1],
     programmed to act as an SPI slave device

and all the transactions were additionally checked on my Logic Analyzer
to make sure the SCK frequencies were actually correct.

This series is supposed to go via SPI tree. All other related SPI
changes are independent from this series and will go via Krzysztof's
tree.

Changes in v2:
  - Collected R-b tags
  - Split the initial submission [1] by 2 patch series
  - Changed bindings patch title to "spi: dt-bindings: ..."

[1] https://www.96boards.org/product/sensors-mezzanine/
[2] https://lore.kernel.org/all/20240120012948.8836-1-semen.protsenko@linaro.org/

Sam Protsenko (2):
  spi: dt-bindings: samsung: Add Exynos850 SPI
  spi: s3c64xx: Add Exynos850 support

 .../devicetree/bindings/spi/samsung,spi.yaml       |  1 +
 drivers/spi/spi-s3c64xx.c                          | 14 ++++++++++++++
 2 files changed, 15 insertions(+)