@@ -103,6 +103,11 @@
allwinner,drive = <SUN4I_PINCTRL_40_MA>;
};
+&osc32k {
+ /* osc32k input is from AC100 */
+ clocks = <&ac100_rtc 0>;
+};
+
&pio {
led_pins_cubieboard4: led-pins@0 {
allwinner,pins = "PH6", "PH17";
@@ -152,6 +152,11 @@
status = "okay";
};
+&osc32k {
+ /* osc32k input is from AC100 */
+ clocks = <&ac100_rtc 0>;
+};
+
&pio {
led_pins_optimus: led-pins@0 {
allwinner,pins = "PH0", "PH1";
@@ -148,15 +148,12 @@
/*
* The 32k clock is from an external source, normally the
- * AC100 codec/RTC chip. This clock is by default enabled
- * and clocked at 32768 Hz, from the oscillator connected
- * to the AC100. It is configurable, but no such driver or
- * bindings exist yet.
+ * AC100 codec/RTC chip. This serves as a placeholder for
+ * board dts files to specify the source.
*/
osc32k: osc32k_clk {
#clock-cells = <0>;
- compatible = "fixed-clock";
- clock-frequency = <32768>;
+ compatible = "fixed-factor-clock";
clock-output-names = "osc32k";
};
The 32.768 kHz clock inside the A80 SoC is fed from an external source, typically the AC100 RTC module. Make the osc32k placeholder a fixed-factor clock so board dts files can specify its source. Signed-off-by: Chen-Yu Tsai <wens@csie.org> --- Changes since v2: none Changes since v1: none --- arch/arm/boot/dts/sun9i-a80-cubieboard4.dts | 5 +++++ arch/arm/boot/dts/sun9i-a80-optimus.dts | 5 +++++ arch/arm/boot/dts/sun9i-a80.dtsi | 9 +++------ 3 files changed, 13 insertions(+), 6 deletions(-)