@@ -22,6 +22,7 @@
#include "clk-regmap-mux.h"
#include "common.h"
#include "gdsc.h"
+#include "reset.h"
enum {
P_BI_TCXO,
@@ -221,7 +222,7 @@ static struct clk_rcg2 lpass_aon_cc_main_rcg_clk_src = {
.parent_data = lpass_aon_cc_parent_data_0,
.num_parents = ARRAY_SIZE(lpass_aon_cc_parent_data_0),
.flags = CLK_OPS_PARENT_ENABLE,
- .ops = &clk_rcg2_ops,
+ .ops = &clk_rcg2_shared_ops,
},
};
@@ -665,6 +666,18 @@ static const struct qcom_cc_desc lpass_audio_cc_sc7280_desc = {
.num_clks = ARRAY_SIZE(lpass_audio_cc_sc7280_clocks),
};
+static const struct qcom_reset_map lpass_audio_cc_sc7280_resets[] = {
+ [LPASS_AUDIO_SWR_RX_CGCR] = { 0xa0, 1 },
+ [LPASS_AUDIO_SWR_TX_CGCR] = { 0xa8, 1 },
+ [LPASS_AUDIO_SWR_WSA_CGCR] = { 0xb0, 1 },
+};
+
+static const struct qcom_cc_desc lpass_audio_cc_reset_sc7280_desc = {
+ .config = &lpass_audio_cc_sc7280_regmap_config,
+ .resets = lpass_audio_cc_sc7280_resets,
+ .num_resets = ARRAY_SIZE(lpass_audio_cc_sc7280_resets),
+};
+
static const struct of_device_id lpass_audio_cc_sc7280_match_table[] = {
{ .compatible = "qcom,sc7280-lpassaudiocc" },
{ }
@@ -741,6 +754,8 @@ static int lpass_audio_cc_sc7280_probe(struct platform_device *pdev)
return ret;
}
+ ret = qcom_cc_probe_by_index(pdev, 1, &lpass_audio_cc_reset_sc7280_desc);
+
pm_runtime_mark_last_busy(&pdev->dev);
pm_runtime_put_autosuspend(&pdev->dev);
pm_runtime_put_sync(&pdev->dev);
@@ -190,6 +190,19 @@ static struct clk_rcg2 lpass_core_cc_ext_if1_clk_src = {
},
};
+static struct clk_rcg2 lpass_core_cc_ext_mclk0_clk_src = {
+ .cmd_rcgr = 0x20000,
+ .mnd_width = 8,
+ .hid_width = 5,
+ .parent_map = lpass_core_cc_parent_map_0,
+ .freq_tbl = ftbl_lpass_core_cc_ext_if0_clk_src,
+ .clkr.hw.init = &(const struct clk_init_data){
+ .name = "lpass_core_cc_ext_mclk0_clk_src",
+ .parent_data = lpass_core_cc_parent_data_0,
+ .num_parents = ARRAY_SIZE(lpass_core_cc_parent_data_0),
+ .ops = &clk_rcg2_ops,
+ },
+};
static struct clk_branch lpass_core_cc_core_clk = {
.halt_reg = 0x1f000,
@@ -283,6 +296,24 @@ static struct clk_branch lpass_core_cc_lpm_mem0_core_clk = {
},
};
+static struct clk_branch lpass_core_cc_ext_mclk0_clk = {
+ .halt_reg = 0x20014,
+ .halt_check = BRANCH_HALT,
+ .clkr = {
+ .enable_reg = 0x20014,
+ .enable_mask = BIT(0),
+ .hw.init = &(const struct clk_init_data){
+ .name = "lpass_core_cc_ext_mclk0_clk",
+ .parent_hws = (const struct clk_hw*[]){
+ &lpass_core_cc_ext_mclk0_clk_src.clkr.hw,
+ },
+ .num_parents = 1,
+ .flags = CLK_SET_RATE_PARENT,
+ .ops = &clk_branch2_ops,
+ },
+ },
+};
+
static struct clk_branch lpass_core_cc_sysnoc_mport_core_clk = {
.halt_reg = 0x23000,
.halt_check = BRANCH_HALT_VOTED,
@@ -326,6 +357,8 @@ static struct clk_regmap *lpass_core_cc_sc7280_clocks[] = {
[LPASS_CORE_CC_LPM_CORE_CLK] = &lpass_core_cc_lpm_core_clk.clkr,
[LPASS_CORE_CC_LPM_MEM0_CORE_CLK] = &lpass_core_cc_lpm_mem0_core_clk.clkr,
[LPASS_CORE_CC_SYSNOC_MPORT_CORE_CLK] = &lpass_core_cc_sysnoc_mport_core_clk.clkr,
+ [LPASS_CORE_CC_EXT_MCLK0_CLK] = &lpass_core_cc_ext_mclk0_clk.clkr,
+ [LPASS_CORE_CC_EXT_MCLK0_CLK_SRC] = &lpass_core_cc_ext_mclk0_clk_src.clkr,
};
static struct regmap_config lpass_core_cc_sc7280_regmap_config = {
The clock gating control for TX/RX/WSA core bus clocks would be required to be reset(moved from hardware control) from audio core driver. Thus add the support for the reset clocks. Also add the external mclk to interface external MI2S. Fixes: 2b75e142523e ("clk: qcom: lpass: Add support for LPASS clock controller for SC7280"). Signed-off-by: Taniya Das <quic_tdas@quicinc.com> --- drivers/clk/qcom/lpassaudiocc-sc7280.c | 17 ++++++++++++- drivers/clk/qcom/lpasscorecc-sc7280.c | 33 ++++++++++++++++++++++++++ 2 files changed, 49 insertions(+), 1 deletion(-) -- 2.17.1