diff mbox series

[18/31] crypto: qat - enable ring after pair is programmed

Message ID 20201012203847.340030-19-giovanni.cabiddu@intel.com (mailing list archive)
State Accepted
Delegated to: Herbert Xu
Headers show
Series crypto: qat - rework in preparation for qat_4xxx driver | expand

Commit Message

Cabiddu, Giovanni Oct. 12, 2020, 8:38 p.m. UTC 
Enable arbitration on the TX ring only after the RX ring is programmed.

Before this change, arbitration was enabled on the TX ring before the RX
ring was programmed allowing the HW to process a request before having
the ring pair configured.
With this change, the arbitration logic is programmed only if the TX
half of the ring mask matches the RX half.

This change does not affect QAT GEN2 devices (c62x, c3xxx and dh895xcc),
but it is a must for QAT GEN4 devices since the CSRs of the ring pair
are locked after arbitration is enabled on the TX ring.

Signed-off-by: Giovanni Cabiddu <giovanni.cabiddu@intel.com>
Reviewed-by: Wojciech Ziemba <wojciech.ziemba@intel.com>
Reviewed-by: Maksim Lukoshkov <maksim.lukoshkov@intel.com>
Reviewed-by: Fiona Trahe <fiona.trahe@intel.com>
Reviewed-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
---
 .../crypto/qat/qat_common/adf_hw_arbiter.c    | 20 ++++++++++++++++++-
 1 file changed, 19 insertions(+), 1 deletion(-)
diff mbox series

Patch

diff --git a/drivers/crypto/qat/qat_common/adf_hw_arbiter.c b/drivers/crypto/qat/qat_common/adf_hw_arbiter.c
index 9dc9d58f6093..bd03c8f54eb4 100644
--- a/drivers/crypto/qat/qat_common/adf_hw_arbiter.c
+++ b/drivers/crypto/qat/qat_common/adf_hw_arbiter.c
@@ -55,9 +55,27 @@  EXPORT_SYMBOL_GPL(adf_init_arb);
 
 void adf_update_ring_arb(struct adf_etr_ring_data *ring)
 {
+	struct adf_accel_dev *accel_dev = ring->bank->accel_dev;
+	struct adf_hw_device_data *hw_data = accel_dev->hw_device;
+	u32 tx_ring_mask = hw_data->tx_rings_mask;
+	u32 shift = hw_data->tx_rx_gap;
+	u32 arben, arben_tx, arben_rx;
+	u32 rx_ring_mask;
+
+	/*
+	 * Enable arbitration on a ring only if the TX half of the ring mask
+	 * matches the RX part. This results in writes to CSR on both TX and
+	 * RX update - only one is necessary, but both are done for
+	 * simplicity.
+	 */
+	rx_ring_mask = tx_ring_mask << shift;
+	arben_tx = (ring->bank->ring_mask & tx_ring_mask) >> 0;
+	arben_rx = (ring->bank->ring_mask & rx_ring_mask) >> shift;
+	arben = arben_tx & arben_rx;
+
 	WRITE_CSR_ARB_RINGSRVARBEN(ring->bank->csr_addr,
 				   ring->bank->bank_number,
-				   ring->bank->ring_mask & 0xFF);
+				   arben);
 }
 
 void adf_exit_arb(struct adf_accel_dev *accel_dev)