@@ -69,6 +69,56 @@ static int __init omapl138_hawk_config_emac(void)
}
device_initcall(omapl138_hawk_config_emac);
+/*
+ * The following EDMA channels/slots are not being used by drivers (for
+ * example: Timer, GPIO, UART events etc) on da850/omap-l138 EVM, hence
+ * they are being reserved for codecs on the DSP side.
+ */
+static const s16 da850_dma0_rsv_chans[][2] = {
+ /* (offset, number) */
+ { 8, 6},
+ {24, 4},
+ {30, 2},
+ {-1, -1}
+};
+
+static const s16 da850_dma0_rsv_slots[][2] = {
+ /* (offset, number) */
+ { 8, 6},
+ {24, 4},
+ {30, 50},
+ {-1, -1}
+};
+
+static const s16 da850_dma1_rsv_chans[][2] = {
+ /* (offset, number) */
+ { 0, 28},
+ {30, 2},
+ {-1, -1}
+};
+
+static const s16 da850_dma1_rsv_slots[][2] = {
+ /* (offset, number) */
+ { 0, 28},
+ {30, 90},
+ {-1, -1}
+};
+
+static struct edma_rsv_info da850_edma_cc0_rsv = {
+ .rsv_chans = da850_dma0_rsv_chans,
+ .rsv_slots = da850_dma0_rsv_slots,
+};
+
+static struct edma_rsv_info da850_edma_cc1_rsv = {
+ .rsv_chans = da850_dma1_rsv_chans,
+ .rsv_slots = da850_dma1_rsv_slots,
+};
+
+static struct edma_rsv_info *da850_edma_rsv[2] = {
+ &da850_edma_cc0_rsv,
+ &da850_edma_cc1_rsv,
+};
+
static struct davinci_uart_config omapl138_hawk_uart_config __initdata = {
.enabled_uarts = 0x7,
};
@@ -79,6 +129,11 @@ static __init void omapl138_hawk_init(void)
davinci_serial_init(&omapl138_hawk_uart_config);
+ ret = da850_register_edma(da850_edma_rsv);
+ if (ret)
+ pr_warning("omapl138_hawk_init: "
+ "edma registration failed: %d\n", ret);
+
ret = da8xx_register_watchdog();
if (ret)
pr_warning("omapl138_hawk_init: "