@@ -1294,7 +1294,7 @@ static int nbpf_probe(struct platform_device *pdev)
struct device_node *np = dev->of_node;
struct nbpf_device *nbpf;
struct dma_device *dma_dev;
- struct resource *iomem, *irq_res;
+ struct resource *iomem;
const struct nbpf_config *cfg;
int num_channels;
int ret, irq, eirq, i;
@@ -1335,13 +1335,11 @@ static int nbpf_probe(struct platform_device *pdev)
nbpf->config = cfg;
for (i = 0; irqs < ARRAY_SIZE(irqbuf); i++) {
- irq_res = platform_get_resource(pdev, IORESOURCE_IRQ, i);
- if (!irq_res)
- break;
-
- for (irq = irq_res->start; irq <= irq_res->end;
- irq++, irqs++)
- irqbuf[irqs] = irq;
+ irq = platform_get_irq_optional(pdev, i);
+ if (irq < 0 && irq != -ENXIO)
+ return irq;
+ if (irq > 0)
+ irqbuf[irqs++] = irq;
}
/*
platform_get_resource(pdev, IORESOURCE_IRQ, ..) relies on static allocation of IRQ resources in DT core code, this causes an issue when using hierarchical interrupt domains using "interrupts" property in the node as this bypasses the hierarchical setup and messes up the irq chaining. In preparation for removal of static setup of IRQ resource from DT core code use platform_get_irq_optional(). There are no non-DT users for this driver so interrupt range (irq_res->start-irq_res->end) is no longer required and with DT we will be sure it will be a single IRQ resource for each index. Signed-off-by: Lad Prabhakar <prabhakar.mahadev-lad.rj@bp.renesas.com> --- v1->v2 * Updated the check to consider 0 as no IRQ --- drivers/dma/nbpfaxi.c | 14 ++++++-------- 1 file changed, 6 insertions(+), 8 deletions(-)