@@ -157,6 +157,20 @@ static struct gpio overo_dss_gpios[] __initdata = {
{ OVERO_GPIO_LCD_BL, GPIOF_OUT_INIT_HIGH, "OVERO_GPIO_LCD_BL" },
};
+static struct tfp410_platform_data dvi_panel = {
+ .name = "dvi",
+ .source = "dpi.0",
+ .data_lines = 24,
+ .i2c_bus_num = 3,
+ .power_down_gpio = -1,
+};
+
+static struct platform_device overo_dvi_device = {
+ .name = "tfp410",
+ .id = 0,
+ .dev.platform_data = &dvi_panel,
+};
+
static void __init overo_display_init(void)
{
if (gpio_request_array(overo_dss_gpios, ARRAY_SIZE(overo_dss_gpios))) {
@@ -166,20 +180,9 @@ static void __init overo_display_init(void)
gpio_export(OVERO_GPIO_LCD_EN, 0);
gpio_export(OVERO_GPIO_LCD_BL, 0);
-}
-static struct tfp410_platform_data dvi_panel = {
- .i2c_bus_num = 3,
- .power_down_gpio = -1,
-};
-
-static struct omap_dss_device overo_dvi_device = {
- .name = "dvi",
- .type = OMAP_DISPLAY_TYPE_DPI,
- .driver_name = "tfp410",
- .data = &dvi_panel,
- .phy.dpi.data_lines = 24,
-};
+ platform_device_register(&overo_dvi_device);
+}
static struct omap_dss_device overo_tv_device = {
.name = "tv",
@@ -235,7 +238,6 @@ static struct omap_dss_device overo_lcd35_device = {
#endif
static struct omap_dss_device *overo_dss_devices[] = {
- &overo_dvi_device,
&overo_tv_device,
#if defined(CONFIG_PANEL_LGPHILIPS_LB035Q02) || \
defined(CONFIG_PANEL_LGPHILIPS_LB035Q02_MODULE)
@@ -247,7 +249,7 @@ static struct omap_dss_device *overo_dss_devices[] = {
static struct omap_dss_board_info overo_dss_data = {
.num_devices = ARRAY_SIZE(overo_dss_devices),
.devices = overo_dss_devices,
- .default_device = &overo_dvi_device,
+ .default_display_name = "dvi",
};
static struct mtd_partition overo_nand_partitions[] = {
Use the new TFP410 platform driver instead of the old omap_dss_driver. Signed-off-by: Tomi Valkeinen <tomi.valkeinen@ti.com> --- arch/arm/mach-omap2/board-overo.c | 32 +++++++++++++++++--------------- 1 file changed, 17 insertions(+), 15 deletions(-)