| Message ID | 201502122211.28752.linux@rainbow-software.org (mailing list archive) |
|---|---|
| State | New, archived |
| Headers | show |
--- a/drivers/video/fbdev/gxt4500.c +++ b/drivers/video/fbdev/gxt4500.c @@ -137,8 +137,8 @@ static const unsigned char watfmt[] = { /* Colormap array; 1k entries of 4 bytes each */ #define CMAP 0x6000 -#define readreg(par, reg) readl((par)->regs + (reg)) -#define writereg(par, reg, val) writel((val), (par)->regs + (reg)) +#define readreg(par, reg) be32_to_cpu(readl((par)->regs + (reg))) +#define writereg(par, reg, val) writel(cpu_to_be32(val), (par)->regs + (reg)) struct gxt4500_par { void __iomem *regs;
Hello, I'm trying to get gxt4500 driver to work on x86 with Diamond/ATI Fire GL2 AGP card: 01:00.0 VGA compatible controller [0300]: IBM GXT6000P Graphics Adapter [1014:0170] (rev 02) (prog-if 00 [VGA controller]) Subsystem: Diamond Multimedia Systems Fire GL2 [1092:0172] Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR+ FastB2B+ DisINTx- Status: Cap+ 66MHz+ UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx- Interrupt: pin A routed to IRQ 16 Region 0: Memory at f5000000 (32-bit, non-prefetchable) [size=128K] Region 1: Memory at f0000000 (32-bit, non-prefetchable) [size=64M] [virtual] Expansion ROM at 30000000 [disabled] [size=256K] Capabilities: [60] Power Management version 0 Flags: PMEClk- DSI+ D1+ D2+ AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-) Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=0 PME- Capabilities: [70] AGP version 2.0 Status: RQ=32 Iso- ArqSz=0 Cal=0 SBA+ ITACoh- GART64- HTrans- 64bit- FW- AGP3- Rate=x1,x2,x4 Command: RQ=1 ArqSz=0 Cal=0 SBA- AGP- GART64- 64bit- FW- Rate=x1 Kernel driver in use: gxt4500 After patching Kconfig, the driver compiled but does not work - monitor shows no signal after driver load. Realized that PPC is big-endian while x86 is little-endian and there are no endian conversions in the driver so did this: But nothing changed, still no signal. Any ideas? I was able to get the ancient fgl23 driver (from AMD web site) to work by installing Debian Woody to a small partition. It's not very useful today but it might be possible to dump the chip's registers and compare with gxt4500.