@@ -25,7 +25,6 @@ struct panel_drv_data {
struct omap_video_timings timings;
- enum omap_dss_venc_type connector_type;
bool invert_polarity;
};
@@ -45,10 +44,6 @@ static const struct omap_video_timings tvc_pal_timings = {
static const struct of_device_id tvc_of_match[];
-struct tvc_of_data {
- enum omap_dss_venc_type connector_type;
-};
-
#define to_panel_data(x) container_of(x, struct panel_drv_data, dssdev)
static int tvc_connect(struct omap_dss_device *dssdev)
@@ -99,7 +94,7 @@ static int tvc_enable(struct omap_dss_device *dssdev)
in->ops.atv->set_timings(in, &ddata->timings);
if (!ddata->dev->of_node) {
- in->ops.atv->set_type(in, ddata->connector_type);
+ in->ops.atv->set_type(in, OMAP_DSS_VENC_TYPE_COMPOSITE);
in->ops.atv->invert_vid_out_polarity(in,
ddata->invert_polarity);
@@ -207,7 +202,6 @@ static int tvc_probe_pdata(struct platform_device *pdev)
ddata->in = in;
- ddata->connector_type = pdata->connector_type;
ddata->invert_polarity = pdata->invert_polarity;
dssdev = &ddata->dssdev;
In legacy mode (non DT mode) support only composite connector type. The only user for this is rx51, using composite type. Dropping the connector_type selection via pdata will allow cleanups in omapdss (drm vs fbdev). Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com> --- drivers/video/fbdev/omap2/omapfb/displays/connector-analog-tv.c | 8 +------- 1 file changed, 1 insertion(+), 7 deletions(-)