diff mbox

[v2,04/11] doc: dt: document altera-passive-serial binding

Message ID 20170614153635.2763-5-atull@kernel.org (mailing list archive)
State Accepted, archived
Headers show

Commit Message

Alan Tull June 14, 2017, 3:36 p.m. UTC 
From: Joshua Clayton <stillcompiling@gmail.com>

Describe an altera-passive-serial devicetree entry, required features

Signed-off-by: Joshua Clayton <stillcompiling@gmail.com>
Acked-by: Rob Herring <robh@kernel.org>
Signed-off-by: Alan Tull <atull@kernel.org>
---
 .../bindings/fpga/altera-passive-serial.txt        | 29 ++++++++++++++++++++++
 1 file changed, 29 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/fpga/altera-passive-serial.txt
diff mbox

Patch

diff --git a/Documentation/devicetree/bindings/fpga/altera-passive-serial.txt b/Documentation/devicetree/bindings/fpga/altera-passive-serial.txt
new file mode 100644
index 0000000..48478bc
--- /dev/null
+++ b/Documentation/devicetree/bindings/fpga/altera-passive-serial.txt
@@ -0,0 +1,29 @@ 
+Altera Passive Serial SPI FPGA Manager
+
+Altera FPGAs support a method of loading the bitstream over what is
+referred to as "passive serial".
+The passive serial link is not technically SPI, and might require extra
+circuits in order to play nicely with other SPI slaves on the same bus.
+
+See https://www.altera.com/literature/hb/cyc/cyc_c51013.pdf
+
+Required properties:
+- compatible: Must be one of the following:
+	"altr,fpga-passive-serial",
+	"altr,fpga-arria10-passive-serial"
+- reg: SPI chip select of the FPGA
+- nconfig-gpios: config pin (referred to as nCONFIG in the manual)
+- nstat-gpios: status pin (referred to as nSTATUS in the manual)
+
+Optional properties:
+- confd-gpios: confd pin (referred to as CONF_DONE in the manual)
+
+Example:
+	fpga: fpga@0 {
+		compatible = "altr,fpga-passive-serial";
+		spi-max-frequency = <20000000>;
+		reg = <0>;
+		nconfig-gpios = <&gpio4 9 GPIO_ACTIVE_LOW>;
+		nstat-gpios = <&gpio4 11 GPIO_ACTIVE_LOW>;
+		confd-gpios = <&gpio4 12 GPIO_ACTIVE_LOW>;
+	};