Series |
ASoC: tas27{64,70}: improve support for Apple codec variants
|
expand
-
[v2,00/29] ASoC: tas27{64,70}: improve support for Apple codec variants
-
[v2,01/29] ASoC: tas2764: Fix power control mask
-
[v2,02/29] ASoC: tas2770: Fix volume scale
-
[v2,03/29] ASoC: dt-bindings: tas27xx: add compatible for SN012776
-
[v2,04/29] ASoC: dt-bindings: tas2770: add compatible for TAS5770L
-
[v2,05/29] ASoC: tas2764: Extend driver to SN012776
-
[v2,06/29] ASoC: tas2764: Add control concerning overcurrent events
-
[v2,07/29] ASoC: tas2770: Factor out set_ivsense_slots
-
[v2,08/29] ASoC: tas2770: Fix and redo I/V sense TDM slot setting logic
-
[v2,09/29] ASoC: tas2764: Reinit cache on part reset
-
[v2,10/29] ASoC: tas2764: Configure zeroing of SDOUT slots
-
[v2,11/29] ASoC: tas2764: Apply Apple quirks
-
[v2,12/29] ASoC: tas2764: Raise regmap range maximum
-
[v2,13/29] ASoC: tas2770: Export 'die_temp' to sysfs
-
[v2,14/29] ASoC: tas2770: expose die temp to hwmon
-
[v2,15/29] ASoC: tas2764: Export 'die_temp' to sysfs
-
[v2,16/29] ASoC: tas2764: expose die temp to hwmon
-
[v2,17/29] ASoC: tas2764: Crop SDOUT zero-out mask based on BCLK ratio
-
[v2,18/29] ASoC: tas2764: Enable main IRQs
-
[v2,19/29] ASoC: tas2764: Power up/down amp on mute ops
-
[v2,20/29] ASoC: tas2764: Add SDZ regulator
-
[v2,21/29] ASoC: tas2764: Add reg defaults for TAS2764_INT_CLK_CFG
-
[v2,22/29] ASoC: tas2764: Mark SW_RESET as volatile
-
[v2,23/29] ASoC: tas2764: Wait for ramp-down after shutdown
-
[v2,24/29] ASoC: tas2770: Add SDZ regulator
-
[v2,25/29] ASoC: tas2770: Power cycle amp on ISENSE/VSENSE change
-
[v2,26/29] ASoC: tas2770: Add zero-fill and pull-down controls
-
[v2,27/29] ASoC: tas2770: Support setting the PDM TX slot
-
[v2,28/29] ASoC: tas2764: Set the SDOUT polarity correctly
-
[v2,29/29] ASoC: tas2770: Set the SDOUT polarity correctly
|