new file mode 100644
@@ -0,0 +1,98 @@
+Kernel driver ir35215
+=====================
+
+Supported chips:
+ * Infinion IR35215
+ Prefix: 'ir35215'
+ Addresses scanned: -
+ Datasheet: Datasheet is not publicly available.
+ * Infinion IR3570B
+ Prefix: 'ir3570b'
+ Addresses scanned: -
+ Datasheet: Datasheet is not publicly available.
+
+Author: Ruslan Babayev <ruslan@babayev.com>
+
+
+Description
+-----------
+
+IR35215 is a Dual Output Digital Multi-Phase Controller
+
+
+Usage Notes
+-----------
+
+This driver does not probe for PMBus devices. You will have to instantiate
+devices explicitly.
+
+Example: the following commands will load the driver for an IR35215
+at address 0x40 on I2C bus #4:
+
+# modprobe ir35215
+# echo ir35215 0x40 > /sys/bus/i2c/devices/i2c-4/new_device
+
+
+Sysfs attributes
+----------------
+
+curr[1-2]_label "iin[1-2]"
+curr[1-2]_input Measured input current
+curr[1-2]_max Maximum current for
+curr[1-2]_max_alarm Current high alarm
+
+curr[3-4]_label "iout[3-4]"
+curr[3-4]_input Measured output current
+curr[3-4]_crit Critical maximum current
+curr[3-4]_crit_alarm Current critical high alarm
+curr[3-4]_highest Highest output current
+curr[3-4]_lowest Lowest output current
+curr[3-4]_max Maximum current
+curr[3-4]_max_alarm Current high alarm
+
+in[1-2]_label "vin[1-2]"
+in[1-2]_input Measured input voltage
+in[1-2]_crit Critical maximum input voltage
+in[1-2]_crit_alarm Input voltage critical high alarm
+in[1-2]_highest Highest input voltage
+in[1-2]_lowest Lowest input voltage
+in[1-2]_min Minimum input voltage
+in[1-2]_min_alarm Input voltage low alarm
+
+in[3-4]_label "vout[3-4]"
+in[3-4]_input Measured output voltage
+in[3-4]_lcrit Critical minimum output voltage
+in[3-4]_lcrit_alarm Output voltage critical low alarm
+in[3-4]_crit Critical maximum output voltage
+in[3-4]_crit_alarm Output voltage critical high alarm
+in[3-4]_highest Highest output voltage
+in[3-4]_lowest Lowest output voltage
+in[3-4]_max Maximum output voltage
+in[3-4]_max_alarm Output voltage high alarm
+in[3-4]_min Minimum output voltage
+in[3-4]_min_alarm Output voltage low alarm
+
+out[1-2]_command Commanded output voltage
+out[1-2]_margin_high Output voltage when operation is set to "high"
+out[1-2]_margin_low Output voltage when operation is set to "low"
+out[1-2]_max Maximum output voltage
+out[1-2]_max_alarm Output voltage high alarm
+out[1-2]_operation Set the output voltage to "on", "off", "high" or "low"
+
+power1_label "pin"
+power1_input Measured input power
+power1_alarm Input power high alarm
+power1_max Input power limit
+
+power[2-3]_label "pout[1-2]"
+power[2-3]_input Measured output power
+power[2-3]_max Output power limit
+power[2-3]_max_alarm Output power high alarm
+
+temp[1-2]_input Measured temperature
+temp[1-2]_crit Critical high temperature
+temp[1-2]_crit_alarm Chip temperature critical high alarm
+temp[1-2]_highest Highest temperature
+temp[1-2]_lowest Lowest temperature
+temp[1-2]_max Maximum temperature
+temp[1-2]_max_alarm Chip temperature high alarm
@@ -45,6 +45,16 @@ config SENSORS_IBM_CFFPS
This driver can also be built as a module. If so, the module will
be called ibm-cffps.
+config SENSORS_IR35215
+ tristate "Infineon IR35215"
+ default n
+ help
+ If you say yes here you get hardware monitoring support for the
+ Infineon IR35215 controller.
+
+ This driver can also be built as a module. If so, the module will
+ be called ir35215.
+
config SENSORS_IR35221
tristate "Infineon IR35221"
help
@@ -7,6 +7,7 @@ obj-$(CONFIG_PMBUS) += pmbus_core.o
obj-$(CONFIG_SENSORS_PMBUS) += pmbus.o
obj-$(CONFIG_SENSORS_ADM1275) += adm1275.o
obj-$(CONFIG_SENSORS_IBM_CFFPS) += ibm-cffps.o
+obj-$(CONFIG_SENSORS_IR35215) += ir35215.o
obj-$(CONFIG_SENSORS_IR35221) += ir35221.o
obj-$(CONFIG_SENSORS_LM25066) += lm25066.o
obj-$(CONFIG_SENSORS_LTC2978) += ltc2978.o
new file mode 100644
@@ -0,0 +1,91 @@
+/*
+ * Hardware monitoring driver for Infineon IR35215
+ *
+ * Copyright (c) 2019 Cisco Systems.
+ *
+ * This program is free software; you can redistribute it and/or modify
+ * it under the terms of the GNU General Public License as published by
+ * the Free Software Foundation; either version 2 of the License, or
+ * (at your option) any later version.
+ *
+ * This program is distributed in the hope that it will be useful,
+ * but WITHOUT ANY WARRANTY; without even the implied warranty of
+ * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
+ * GNU General Public License for more details.
+ */
+
+#include <linux/kernel.h>
+#include <linux/module.h>
+#include <linux/init.h>
+#include <linux/err.h>
+#include <linux/i2c.h>
+#include "pmbus.h"
+
+#define COMMON_FUNCS (PMBUS_HAVE_VIN | PMBUS_HAVE_VOUT \
+ | PMBUS_HAVE_IIN | PMBUS_HAVE_IOUT \
+ | PMBUS_HAVE_PIN | PMBUS_HAVE_POUT \
+ | PMBUS_HAVE_TEMP \
+ | PMBUS_HAVE_STATUS_VOUT \
+ | PMBUS_HAVE_STATUS_IOUT \
+ | PMBUS_HAVE_STATUS_INPUT \
+ | PMBUS_HAVE_STATUS_TEMP \
+ | PMBUS_HAVE_VOUT_MARGIN_HIGH \
+ | PMBUS_HAVE_VOUT_MARGIN_LOW \
+ )
+
+
+#define IR35215_FUNCS (COMMON_FUNCS | PMBUS_HAVE_VOUT_COMMAND)
+#define IR3570B_FUNCS (COMMON_FUNCS | PMBUS_HAVE_TEMP2)
+
+static struct pmbus_driver_info ir35215_info = {
+ .pages = 2,
+ .format[PSC_VOLTAGE_IN] = linear,
+ .format[PSC_VOLTAGE_OUT] = linear,
+ .format[PSC_CURRENT_IN] = linear,
+ .format[PSC_CURRENT_OUT] = linear,
+ .format[PSC_POWER] = linear,
+ .format[PSC_TEMPERATURE] = linear,
+ .func[0] = IR35215_FUNCS,
+ .func[1] = IR35215_FUNCS,
+};
+
+static struct pmbus_driver_info ir3570b_info = {
+ .pages = 1,
+ .format[PSC_VOLTAGE_IN] = linear,
+ .format[PSC_VOLTAGE_OUT] = linear,
+ .format[PSC_CURRENT_IN] = linear,
+ .format[PSC_CURRENT_OUT] = linear,
+ .format[PSC_POWER] = linear,
+ .format[PSC_TEMPERATURE] = linear,
+ .func[0] = IR3570B_FUNCS,
+ .func[1] = IR3570B_FUNCS,
+};
+
+static int ir35215_probe(struct i2c_client *client,
+ const struct i2c_device_id *id)
+{
+ return pmbus_do_probe(client, id, (void *)id->driver_data);
+}
+
+static const struct i2c_device_id ir35215_id[] = {
+ {"ir35215", (kernel_ulong_t)&ir35215_info},
+ {"ir3570b", (kernel_ulong_t)&ir3570b_info},
+ {}
+};
+
+MODULE_DEVICE_TABLE(i2c, ir35215_id);
+
+static struct i2c_driver ir35215_driver = {
+ .driver = {
+ .name = "ir35215",
+ },
+ .probe = ir35215_probe,
+ .remove = pmbus_do_remove,
+ .id_table = ir35215_id,
+};
+
+module_i2c_driver(ir35215_driver);
+
+MODULE_AUTHOR("Ruslan Babayev <ruslan@babayev.com>");
+MODULE_DESCRIPTION("PMBus driver for IR35215");
+MODULE_LICENSE("GPL");