| Message ID | 20231025-ina237-v1-3-a0196119720c@linux.dev (mailing list archive) |
|---|---|
| State | Superseded |
| Headers | show |
| Series | hwmon: add ti,ina237 support to ina238 driver | expand |
diff --git a/drivers/hwmon/ina238.c b/drivers/hwmon/ina238.c index f519c22d3907..ca9f5d2c811b 100644 --- a/drivers/hwmon/ina238.c +++ b/drivers/hwmon/ina238.c @@ -33,7 +33,7 @@ #define INA238_BUS_UNDER_VOLTAGE 0xf #define INA238_TEMP_LIMIT 0x10 #define INA238_POWER_LIMIT 0x11 -#define INA238_DEVICE_ID 0x3f +#define INA238_DEVICE_ID 0x3f /* not available on INA237 */ #define INA238_CONFIG_ADCRANGE BIT(4) @@ -622,6 +622,7 @@ static const struct i2c_device_id ina238_id[] = { MODULE_DEVICE_TABLE(i2c, ina238_id); static const struct of_device_id __maybe_unused ina238_of_match[] = { + { .compatible = "ti,ina237" }, { .compatible = "ti,ina238" }, { }, };
The INA237 "85-V, 16-Bit, Precision Power Monitor With I2C Interface" is basically the same as INA328. Therefore add a corresponding compatible to the driver. According to the datasheet the main difference is the current and power monitoring accuracy: +------------------------+---------------+---------------+ | | INA238 | INA237 | +------------------------+---------------+---------------+ | Offset voltage | +/- 5µV | +/- 50µV | | Offset drift | +/- 0.02µV/°C | +/- 0.02µV/°C | | Gain error | +/- 0.1% | +/- 0.3% | | Gain error drift | +/- 25ppm/°C | +/- 50ppm/°C | | Common mode rejection | 140dB | 120dB | | Power accuracy | 0.7% | 1.6% | +------------------------+---------------+---------------+ As well as the missing DEVICE_ID register at 0x3F, which is currently not in use by the driver. Signed-off-by: Richard Leitner <richard.leitner@linux.dev> --- drivers/hwmon/ina238.c | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-)