diff mbox series

[v4,1/2] dt-bindings: hwmon: ti,ina2xx: Add ti,alert-polarity-active-high property

Message ID 20240611-apol-ina2xx-fix-v4-1-8df1d2282fc5@axis.com (mailing list archive)
State Accepted
Headers show
Series hwmon: (ina2xx):Add Suppor for passing alert polarity from device tree to driver | expand

Commit Message

Amna Waseem June 11, 2024, 9:36 a.m. UTC 
Add a property to the binding to configure the Alert Polarity.
Alert pin is asserted based on the value of Alert Polarity bit of
Mask/Enable register. It is by default 0 which means Alert pin is
configured to be active low open collector. Value of 1 maps to
Inverted (active high open collector).

Signed-off-by: Amna Waseem <Amna.Waseem@axis.com>
---
 Documentation/devicetree/bindings/hwmon/ti,ina2xx.yaml | 9 +++++++++
 1 file changed, 9 insertions(+)
diff mbox series

Patch

diff --git a/Documentation/devicetree/bindings/hwmon/ti,ina2xx.yaml b/Documentation/devicetree/bindings/hwmon/ti,ina2xx.yaml
index df86c2c92037..9190ef0bda54 100644
--- a/Documentation/devicetree/bindings/hwmon/ti,ina2xx.yaml
+++ b/Documentation/devicetree/bindings/hwmon/ti,ina2xx.yaml
@@ -66,6 +66,14 @@  properties:
     description: phandle to the regulator that provides the VS supply typically
       in range from 2.7 V to 5.5 V.
 
+  ti,alert-polarity-active-high:
+    description: Alert pin is asserted based on the value of Alert polarity Bit
+      of Mask/Enable register. Default value is Normal (0 which maps to
+      active-low open collector). The other value is Inverted
+      (1 which maps to active-high open collector). Specify this property to set
+      the alert polarity to active-high. 
+    $ref: /schemas/types.yaml#/definitions/flag
+
 required:
   - compatible
   - reg
@@ -88,5 +96,6 @@  examples:
             label = "vdd_3v0";
             shunt-resistor = <1000>;
             vs-supply = <&vdd_3v0>;
+            ti,alert-polarity-active-high;
         };
     };