[v8,0/2] iio: pressure: dps310: Reset chip if MEAS_CFG is corrupt

Message

Eddie James Sept. 15, 2022, 7:57 p.m. UTC

The DPS310 chip has been observed to get "stuck" such that pressure
and temperature measurements are never indicated as "ready" in the
MEAS_CFG register. The only solution is to reset the device and try
again. In order to avoid continual failures, use a boolean flag to
only try the reset after timeout once if errors persist. Include a
patch to move the startup procedure into a function.

Changes since v7:
 - Condense the code a bit by dropping rc2

Changes since v6:
 - Use helper instead of the lengthy regmap_read_poll_timeout twice
 - Just return dps310_startup in dps310_reset_reinit

Changes since v5:
 - Completely rework the second patch to reset and reinit in any
   timeout condition, if there haven't been previous timeouts that
   failed to recover the chip.

Changes since v4:
 - Just check for rc rather than rc < 0 in some cases
 - Split declaration and init of rc

Changes since v3:
 - Don't check regmap* return codes for < 0
 - Fix comment spelling

Changes since v2:
 - Add some comments
 - Fix the clunky control flow

Changes since v1:
 - Separate into two patches
 - Rename 'dps310_verify_meas_cfg' to 'dps310_check_reset_meas_cfg'

Eddie James (2):
  iio: pressure: dps310: Refactor startup procedure
  iio: pressure: dps310: Reset chip after timeout

 drivers/iio/pressure/dps310.c | 262 +++++++++++++++++++++-------------
 1 file changed, 163 insertions(+), 99 deletions(-)