mbox series

[v2,0/2] input: driver for RPi's official 7" touchscreen

Message ID 20181211112408.9524-1-nsaenzjulienne@suse.de (mailing list archive)
Headers show
Series input: driver for RPi's official 7" touchscreen | expand

Message

Nicolas Saenz Julienne Dec. 11, 2018, 11:23 a.m. UTC
This small series adds support for Raspberry pi's 7" touchscreen. Which
alongside with the backlight driver are the last devices needed to have
a functional touchscreen upstream.

With this setup the board's VC4 firmware takes care of communicating
with the touch chip and provides data though a shared memory area
provided by the driver. The driver takes care of polling the firmware
whenever at around 60Hz since there is no interrupt line available.

The 1.0 revision of the touchscreen is based on the ft5426 chip.
Technically, with some changes in edt-ft54x4.c we should be able to
access the data directly through I2C. Yet this bus is meant to be owned
by RPi's firmware and might access it anytime. For example, to
configure RPi's camera device. As sharing the bus master interface is
not possible a series of alternatives have been tested unsuccessfully
[1]. It seems that we'll be unable to access the chip directly in a
"clean" way which leaves us with this firmware based solution.

The driver was rewritten based on the one available on the downstream
Raspberry Pi kernel tree: https://github.com/raspberrypi/linux/.

This series is based on v4.20-rc6 and was tested on a RPi 3 B+.

Changelog

v1 -> v2:
  - Remove all references to RPi3
  - Spelling errors
  - Rename config string
  - Reorder devm_add_action_or_reset()
  - Remove __set_bit(EV* functions
  - Remove INPUT_MT_POINTER flag
  - Add missing header files
  - Create define to invalidate npointers
  - Fix commit ordering and titles

RFC -> PATCH:
  - Better dependencies check in Kconfig
  - Add SPDX tag
  - Use polled input device API
  - Use input_mt_sync_frame()
  - Drop reference from dt node in probe
  - Use devm where possible
  - Small cosmetic changes

[1] https://lists.infradead.org/pipermail/linux-rpi-kernel/2018-December/008444.html
===

Nicolas Saenz Julienne (2):
  dt-bindings: input: Add Raspberry Pi Touchscreen
  input: add official Raspberry Pi's touchscreen driver

 .../touchscreen/raspberrypi,firmware-ts.txt   |  26 ++
 drivers/input/touchscreen/Kconfig             |  12 +
 drivers/input/touchscreen/Makefile            |   1 +
 drivers/input/touchscreen/raspberrypi-ts.c    | 227 ++++++++++++++++++
 4 files changed, 266 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/input/touchscreen/raspberrypi,firmware-ts.txt
 create mode 100644 drivers/input/touchscreen/raspberrypi-ts.c