@@ -1330,6 +1330,7 @@ static int vidioc_s_std(struct file *file, void *priv, v4l2_std_id * norm)
buffer, which is currently hardcoded at 720x480 */
v4l2_device_call_all(&dev->v4l2_dev, 0, core, s_std, *norm);
+ dev->std_set_in_tuner_core = 1;
return 0;
}
@@ -1540,6 +1541,15 @@ static int vidioc_s_frequency(struct file *file, void *priv,
dev->ctrl_freq = freq->frequency;
+ if (dev->std_set_in_tuner_core == 0) {
+ /* If we've never sent the standard in tuner core, do so now. We
+ don't do this at device probe because we don't want to incur
+ the cost of a firmware load */
+ v4l2_device_call_all(&dev->v4l2_dev, 0, core, s_std,
+ dev->vdev->tvnorms);
+ dev->std_set_in_tuner_core = 1;
+ }
+
v4l2_device_call_all(&dev->v4l2_dev, 0, tuner, s_frequency, freq);
au0828_analog_stream_reset(dev);
@@ -225,6 +225,7 @@ struct au0828_dev {
unsigned int frame_count;
int ctrl_freq;
int input_type;
+ int std_set_in_tuner_core;
unsigned int ctrl_input;
enum au0828_dev_state dev_state;
enum au0828_stream_state stream_state;
If the user performs a tuning attempt without explicitly calling the s_std ioctl(), a value of zero is sent from tuner-core to xc5000. This causes the xc5000 driver to leave the standard unchanged. The problem was masked by the fact that the xc5000 driver defaulted to NTSC, but if you happened to perform an ATSC/ClearQAM tuning attempt and then do an analog tune, the net effect is an analog tune with the standard still set to DTV6. Keep track of whether the standard has ever been sent to tuner-core. We don't make an s_std subdev call explicitly during probe because that will cause a firmware load (which is very time consuming on the 950q). With the logic in this patch, the s_std call will occur automatically on the s_freq call if it hasn't already been set. Signed-off-by: Devin Heitmueller <dheitmueller@kernellabs.com> --- drivers/media/video/au0828/au0828-video.c | 10 ++++++++++ drivers/media/video/au0828/au0828.h | 1 + 2 files changed, 11 insertions(+), 0 deletions(-)