diff mbox

[v2,2/3] dt-bindings: ov5640: Add "rotation" property

Message ID 1529317759-28657-3-git-send-email-hugues.fruchet@st.com (mailing list archive)
State New, archived
Headers show

Commit Message

Hugues FRUCHET June 18, 2018, 10:29 a.m. UTC 
Add the rotation property to the list of optional properties
for the OV5640 camera sensor.

Signed-off-by: Hugues Fruchet <hugues.fruchet@st.com>
---
 Documentation/devicetree/bindings/media/i2c/ov5640.txt | 5 +++++
 1 file changed, 5 insertions(+)

Comments

Rob Herring (Arm) June 20, 2018, 8:01 p.m. UTC | #1 
On Mon, Jun 18, 2018 at 12:29:18PM +0200, Hugues Fruchet wrote:
> Add the rotation property to the list of optional properties
> for the OV5640 camera sensor.
> 
> Signed-off-by: Hugues Fruchet <hugues.fruchet@st.com>
> ---
>  Documentation/devicetree/bindings/media/i2c/ov5640.txt | 5 +++++
>  1 file changed, 5 insertions(+)

Reviewed-by: Rob Herring <robh@kernel.org>
diff mbox

Patch

diff --git a/Documentation/devicetree/bindings/media/i2c/ov5640.txt b/Documentation/devicetree/bindings/media/i2c/ov5640.txt
index 8e36da0..c97c2f2 100644
--- a/Documentation/devicetree/bindings/media/i2c/ov5640.txt
+++ b/Documentation/devicetree/bindings/media/i2c/ov5640.txt
@@ -13,6 +13,10 @@  Optional Properties:
 	       This is an active low signal to the OV5640.
 - powerdown-gpios: reference to the GPIO connected to the powerdown pin,
 		   if any. This is an active high signal to the OV5640.
+- rotation: as defined in
+	    Documentation/devicetree/bindings/media/video-interfaces.txt,
+	    valid values are 0 (sensor mounted upright) and 180 (sensor
+	    mounted upside down).
 
 The device node must contain one 'port' child node for its digital output
 video port, in accordance with the video interface bindings defined in
@@ -51,6 +55,7 @@  Examples:
 		DVDD-supply = <&vgen2_reg>;  /* 1.5v */
 		powerdown-gpios = <&gpio1 19 GPIO_ACTIVE_HIGH>;
 		reset-gpios = <&gpio1 20 GPIO_ACTIVE_LOW>;
+		rotation = <180>;
 
 		port {
 			/* MIPI CSI-2 bus endpoint */