@@ -18,6 +18,7 @@
#include <linux/platform_device.h>
#include <linux/pm_runtime.h>
#include <linux/regmap.h>
+#include <linux/regulator/consumer.h>
#include <linux/reset.h>
#include <linux/sched.h>
#include <linux/sizes.h>
@@ -36,6 +37,7 @@ struct sun6i_csi_dev {
struct clk *clk_mod;
struct clk *clk_ram;
struct reset_control *rstc_bus;
+ struct regulator *regulator;
int planar_offset[3];
};
@@ -163,9 +165,16 @@ int sun6i_csi_set_power(struct sun6i_csi *csi, bool enable)
clk_disable_unprepare(sdev->clk_ram);
clk_disable_unprepare(sdev->clk_mod);
reset_control_assert(sdev->rstc_bus);
+ regulator_disable(sdev->regulator);
return 0;
}
+ ret = regulator_enable(sdev->regulator);
+ if (ret) {
+ dev_err(sdev->dev, "Enable vcc csi supply err %d\n", ret);
+ return ret;
+ }
+
ret = clk_prepare_enable(sdev->clk_mod);
if (ret) {
dev_err(sdev->dev, "Enable csi clk err %d\n", ret);
@@ -809,6 +818,12 @@ static int sun6i_csi_resource_request(struct sun6i_csi_dev *sdev,
if (IS_ERR(io_base))
return PTR_ERR(io_base);
+ sdev->regulator = devm_regulator_get(&pdev->dev, "vcc-csi");
+ if (IS_ERR(sdev->regulator)) {
+ dev_err(&pdev->dev, "Unable to acquire csi vcc supply\n");
+ return PTR_ERR(sdev->regulator);
+ }
+
sdev->regmap = devm_regmap_init_mmio_clk(&pdev->dev, "bus", io_base,
&sun6i_csi_regmap_config);
if (IS_ERR(sdev->regmap)) {
Most of the Allwinner A64 CSI controllers are supply with VCC-PE pin, which may not be turned on by default. Add support for such boards by adding voltage regulator handling code to sun6i csi driver. Used vcc-csi instead of vcc-pe to have better naming convention wrt other controller pin supplies. Signed-off-by: Jagan Teki <jagan@amarulasolutions.com> --- .../media/platform/sunxi/sun6i-csi/sun6i_csi.c | 15 +++++++++++++++ 1 file changed, 15 insertions(+)