@@ -345,12 +345,16 @@ irqreturn_t ipu6_buttress_isr(int irq, void *isp_ptr)
u32 disable_irqs = 0;
u32 irq_status;
u32 i, count = 0;
+ int active;
- pm_runtime_get_noresume(&isp->pdev->dev);
+ active = pm_runtime_get_if_active(&isp->pdev->dev);
+ if (!active)
+ return IRQ_NONE;
irq_status = readl(isp->base + reg_irq_sts);
- if (!irq_status) {
- pm_runtime_put_noidle(&isp->pdev->dev);
+ if (irq_status == 0 || WARN_ON_ONCE(irq_status == 0xffffffffu)) {
+ if (active > 0)
+ pm_runtime_put_noidle(&isp->pdev->dev);
return IRQ_NONE;
}
@@ -426,7 +430,8 @@ irqreturn_t ipu6_buttress_isr(int irq, void *isp_ptr)
writel(BUTTRESS_IRQS & ~disable_irqs,
isp->base + BUTTRESS_REG_ISR_ENABLE);
- pm_runtime_put(&isp->pdev->dev);
+ if (active > 0)
+ pm_runtime_put(&isp->pdev->dev);
return ret;
}
@@ -752,6 +752,9 @@ static void ipu6_pci_reset_done(struct pci_dev *pdev)
*/
static int ipu6_suspend(struct device *dev)
{
+ struct pci_dev *pdev = to_pci_dev(dev);
+
+ synchronize_irq(pdev->irq);
return 0;
}
Some IPU6 devices have shared interrupts. We need to handle properly case when interrupt is triggered from other device on shared irq line and IPU6 itself disabled. In such case we get 0xffffffff from ISR_STATUS register and handle all irq's cases, for what we are not not prepared and usually hang the whole system. To avoid the issue use pm_runtime_get_if_active() to check if the device is enabled and prevent suspending it when we handle irq until the end of irq. Additionally use synchronize_irq() in suspend Fixes: ab29a2478e70 ("media: intel/ipu6: add IPU6 buttress interface driver") Cc: stable@vger.kernel.org Signed-off-by: Stanislaw Gruszka <stanislaw.gruszka@linux.intel.com> --- drivers/media/pci/intel/ipu6/ipu6-buttress.c | 13 +++++++++---- drivers/media/pci/intel/ipu6/ipu6.c | 3 +++ 2 files changed, 12 insertions(+), 4 deletions(-)