@@ -241,7 +241,7 @@ static void ipu6_isys_try_fmt_cap(struct ipu6_isys_video *av, u32 type,
else
*bytesperline = DIV_ROUND_UP(*width * pfmt->bpp, BITS_PER_BYTE);
- *bytesperline = ALIGN(*bytesperline, av->isys->line_align);
+ *bytesperline = ALIGN(*bytesperline, 64);
/*
* (height + 1) * bytesperline due to a hardware issue: the DMA unit
@@ -1089,7 +1089,6 @@ static int isys_probe(struct auxiliary_device *auxdev,
INIT_LIST_HEAD(&isys->framebuflist);
INIT_LIST_HEAD(&isys->framebuflist_fw);
- isys->line_align = IPU6_ISYS_2600_MEM_LINE_ALIGN;
isys->icache_prefetch = 0;
dev_set_drvdata(&auxdev->dev, isys);
@@ -29,8 +29,6 @@ struct ipu6_bus_device;
IPU6_ISYS_UNISPART_IRQ_CSI0 | \
IPU6_ISYS_UNISPART_IRQ_CSI1)
-#define IPU6_ISYS_2600_MEM_LINE_ALIGN 64
-
/*
* Current message queue configuration. These must be big enough
* so that they never gets full. Queues are located in system memory
@@ -118,7 +116,6 @@ struct sensor_async_sd {
* @streams: streams per firmware stream ID
* @fwcom: fw communication layer private pointer
* or optional external library private pointer
- * @line_align: line alignment in memory
* @phy_termcal_val: the termination calibration value, only used for DWC PHY
* @need_reset: Isys requires d0i0->i3 transition
* @ref_count: total number of callers fw open
@@ -140,7 +137,6 @@ struct ipu6_isys {
struct ipu6_isys_stream streams[IPU6_ISYS_MAX_STREAMS];
int streams_ref_count[IPU6_ISYS_MAX_STREAMS];
void *fwcom;
- unsigned int line_align;
u32 phy_termcal_val;
bool need_reset;
bool icache_prefetch;
isys->line_align value is only used in one place and we can just use the proper value directly there. Signed-off-by: Stanislaw Gruszka <stanislaw.gruszka@linux.intel.com> --- drivers/media/pci/intel/ipu6/ipu6-isys-video.c | 2 +- drivers/media/pci/intel/ipu6/ipu6-isys.c | 1 - drivers/media/pci/intel/ipu6/ipu6-isys.h | 4 ---- 3 files changed, 1 insertion(+), 6 deletions(-)