af9035 test needed!

On Sábado, 12 de enero de 2013 22:14:07 Jose Alberto Reguero escribió:
> On Sábado, 12 de enero de 2013 01:49:21 Antti Palosaari escribió:
> > On 01/12/2013 01:45 AM, Jose Alberto Reguero wrote:
> > > On Viernes, 11 de enero de 2013 20:38:01 Antti Palosaari escribió:
> > >> Hello Jose and Gianluca
> > >> 
> > >> Could you test that (tda18218 & mxl5007t):
> > >> http://git.linuxtv.org/anttip/media_tree.git/shortlog/refs/heads/it9135_t
> > >> une r
> > >> 
> > >> I wonder if ADC config logic still works for superheterodyne tuners
> > >> (tuner having IF). I changed it to adc / 2 always due to IT9135 tuner.
> > >> That makes me wonder it possible breaks tuners having IF, as ADC was
> > >> clocked just over 20MHz and if it is half then it is 10MHz. For BB that
> > >> is enough, but I think that having IF, which is 4MHz at least for 8MHz
> > >> BW it is too less.
> > >> 
> > >> F*ck I hate to maintain driver without a hardware! Any idea where I can
> > >> get AF9035 device having tda18218 or mxl5007t?
> > >> 
> > >> regards
> > >> Antti
> > > 
> > > Still pending the changes for  mxl5007t. Attached is a patch for that.
> > > 
> > > Changes to make work Avermedia Twinstar with the af9035 driver.
> > > 
> > > Signed-off-by: Jose Alberto Reguero <jareguero@telefonica.net>
> > 
> > I cannot do much about this as it changes mxl5007t driver which is not
> > maintained by me. :)
> > 
> > regards
> > Antti
> >
> 
> Adding CC to Michael Krufky because it is the maintainer of mxl5007t driver. 
> Michael, any chance to get this patch merged?
> 
> Jose Alberto
>   
> > > Jose Alberto
> > > 
> > > diff -upr linux/drivers/media/tuners/mxl5007t.c
> > > linux.new/drivers/media/tuners/mxl5007t.c
> > > --- linux/drivers/media/tuners/mxl5007t.c	2012-08-14 05:45:22.000000000
> > > +0200 +++ linux.new/drivers/media/tuners/mxl5007t.c	2013-01-10
> > > 19:23:09.247556275 +0100
> > > @@ -374,7 +374,6 @@ static struct reg_pair_t *mxl5007t_calc_
> > > 
> > >   	mxl5007t_set_if_freq_bits(state, cfg->if_freq_hz, cfg->invert_if);
> > >   	mxl5007t_set_xtal_freq_bits(state, cfg->xtal_freq_hz);
> > > 
> > > -	set_reg_bits(state->tab_init, 0x04, 0x01, cfg->loop_thru_enable);
> > > 
> > >   	set_reg_bits(state->tab_init, 0x03, 0x08, cfg->clk_out_enable << 3);
> > >   	set_reg_bits(state->tab_init, 0x03, 0x07, cfg->clk_out_amp);
> > > 
> > > @@ -531,9 +530,12 @@ static int mxl5007t_tuner_init(struct mx
> > > 
> > >   	struct reg_pair_t *init_regs;
> > >   	int ret;
> > > 
> > > -	ret = mxl5007t_soft_reset(state);
> > > -	if (mxl_fail(ret))
> > > +	if (!state->config->no_reset) {
> > > +		ret = mxl5007t_soft_reset(state);
> > > +		if (mxl_fail(ret))
> > > 
> > >   		goto fail;
> > > 
> > > +	}
> > > +
> > > 
> > >   	/* calculate initialization reg array */
> > >   	init_regs = mxl5007t_calc_init_regs(state, mode);
> > > 
> > > @@ -887,7 +889,12 @@ struct dvb_frontend *mxl5007t_attach(str
> > > 
> > >   		if (fe->ops.i2c_gate_ctrl)
> > >   		
> > >   			fe->ops.i2c_gate_ctrl(fe, 1);
> > > 
> > > -		ret = mxl5007t_get_chip_id(state);
> > > +		if (!state->config->no_probe)
> > > +			ret = mxl5007t_get_chip_id(state);
> > > +
> > > +		ret = mxl5007t_write_reg(state, 0x04,
> > > +			state->config->loop_thru_enable);
> > > +
> > > 
> > >   		if (fe->ops.i2c_gate_ctrl)
> > >   		
> > >   			fe->ops.i2c_gate_ctrl(fe, 0);
> > > 
> > > diff -upr linux/drivers/media/tuners/mxl5007t.h
> > > linux.new/drivers/media/tuners/mxl5007t.h
> > > --- linux/drivers/media/tuners/mxl5007t.h	2012-08-14 05:45:22.000000000
> > > +0200 +++ linux.new/drivers/media/tuners/mxl5007t.h	2013-01-10
> > > 19:19:11.204379581 +0100
> > > @@ -73,8 +73,10 @@ struct mxl5007t_config {
> > > 
> > >   	enum mxl5007t_xtal_freq xtal_freq_hz;
> > >   	enum mxl5007t_if_freq if_freq_hz;
> > >   	unsigned int invert_if:1;
> > > 
> > > -	unsigned int loop_thru_enable:1;
> > > +	unsigned int loop_thru_enable:3;
> > > 
> > >   	unsigned int clk_out_enable:1;
> > > 
> > > +	unsigned int no_probe:1;
> > > +	unsigned int no_reset:1;
> > > 
> > >   };
> > >   
> > >   #if defined(CONFIG_MEDIA_TUNER_MXL5007T) ||
> > > 
> > > (defined(CONFIG_MEDIA_TUNER_MXL5007T_MODULE) && defined(MODULE))
> > > diff -upr linux/drivers/media/usb/dvb-usb-v2/af9035.c
> > > linux.new/drivers/media/usb/dvb-usb-v2/af9035.c
> > > --- linux/drivers/media/usb/dvb-usb-v2/af9035.c	2013-01-07
> > > 05:45:57.000000000 +0100
> > > +++ linux.new/drivers/media/usb/dvb-usb-v2/af9035.c	2013-01-12
> > > 00:30:57.557310465 +0100
> > > @@ -886,13 +886,17 @@ static struct mxl5007t_config af9035_mxl
> > > 
> > >   		.loop_thru_enable = 0,
> > >   		.clk_out_enable = 0,
> > >   		.clk_out_amp = MxL_CLKOUT_AMP_0_94V,
> > > 
> > > +		.no_probe = 1,
> > > +		.no_reset = 1,
> > > 
> > >   	}, {
> > >   	
> > >   		.xtal_freq_hz = MxL_XTAL_24_MHZ,
> > >   		.if_freq_hz = MxL_IF_4_57_MHZ,
> > >   		.invert_if = 0,
> > > 
> > > -		.loop_thru_enable = 1,
> > > +		.loop_thru_enable = 3,
> > > 
> > >   		.clk_out_enable = 1,
> > >   		.clk_out_amp = MxL_CLKOUT_AMP_0_94V,
> > > 
> > > +		.no_probe = 1,
> > > +		.no_reset = 1,
> > > 
> > >   	}
> > >   
> > >   };
> --

Sending again because some lines are mangled.

Changes  to make work Avermedia Twinstar with the af9035 driver.

Signed-off-by: Jose Alberto Reguero <jareguero@telefonica.net>

--
To unsubscribe from this list: send the line "unsubscribe linux-media" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html

af9035 test needed!

Commit Message

Patch