[v3,0/2] media: i2c: Add support for GC08A3 sensor

Message

Zhi Mao (毛智) Jan. 9, 2024, 2:27 a.m. UTC

This series adds YAML DT binding and V4L2 sub-device driver for Galaxycore's
GC08A3 8-megapixel 10-bit RAW CMOS 1/4" sensor, with an MIPI CSI-2 image data
interface and the I2C control bus.

The driver is implemented with V4L2 framework.
 - Async registered as a V4L2 sub-device.
 - As the first component of camera system including Seninf, ISP pipeline.
 - A media entity that provides one source pad in common.
 - Used in camera features on ChromeOS application.

Also this driver supports following features:
 - manual exposure and analog gain control support
 - vertical blanking control support
 - test pattern support
 - media controller support
 - runtime PM support
 - support resolution: 3264x2448@30fps, 1920x1080@60fps

Previous versions of this patch-set can be found here:
v2: https://lore.kernel.org/linux-media/[e-mail]/
v1: https://lore.kernel.org/linux-media/[e-mail]/

This series is based on linux-next, tag: next-20240108
Changes in v3:
- dts-binding files：
-- rename enable-gpio to reset-gpio.
-- remove "status","clock-names" & "clock-frequency" useless infomatin in dts-binding files.
-- remove the modifcation in "vendor-prefixes.yaml" as key words “galaxycore” has been added.

- gc08a sensor driver：
-- rename enable-gpio to reset-gpio in sensor driver
-- remove reset-gpio pull low in start of function：power_on()
-- fix some indentation code style issue in sensor driver probe function
-- remove some dev_info() print log function and some none C style comments in sensor driver
-- remove system suspend/resume operations and implement runtime PM support
-- remove .g_volatile_ctrl() and .try_ctrl() implementations
-- revome g_register/s_register functions
-- remove "mutex" cntrol and use subdev active state
-- remove "fmt&crop" variable in sensor driver and let subdev active state to store them
-- use v4l2-cci api to read/write sensor register
-- remove some dependencies & selection infomation in Kconfig, as they are handled in the VIDEO_CAMERA_SENSOR menu
-- remove .try_ctrl callback function
-- remobe "streaming == enable" in start_stream function
-- use an exact match method in enum_frame_interval() function
-- add "V4L2_SUBDEV_FL_HAS_EVENTS" for sd.flags in probe() function

Thanks

Zhi Mao (2):
  media: dt-bindings: media: i2c: Document GC08A3 bindings
  media: i2c: Add GC08A3 image sensor driver

 .../bindings/media/i2c/galaxycore,gc08a3.yaml |  112 ++
 drivers/media/i2c/Kconfig                     |   10 +
 drivers/media/i2c/Makefile                    |    1 +
 drivers/media/i2c/gc08a3.c                    | 1467 +++++++++++++++++
 4 files changed, 1590 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/media/i2c/galaxycore,gc08a3.yaml
 create mode 100644 drivers/media/i2c/gc08a3.c