@@ -70,8 +70,12 @@
pinctrl-0 = <&mmc0_pins_default>;
pinctrl-1 = <&mmc0_pins_uhs>;
bus-width = <8>;
- max-frequency = <50000000>;
+ max-frequency = <200000000>;
cap-mmc-highspeed;
+ mmc-hs200-1_8v;
+ mmc-hs400-1_8v;
+ cap-mmc-hw-reset;
+ hs400-ds-delay = <0x14015>;
vmmc-supply = <&mt6397_vemc_3v3_reg>;
vqmmc-supply = <&mt6397_vio18_reg>;
non-removable;
@@ -83,9 +87,10 @@
pinctrl-0 = <&mmc1_pins_default>;
pinctrl-1 = <&mmc1_pins_uhs>;
bus-width = <4>;
- max-frequency = <50000000>;
+ max-frequency = <200000000>;
cap-sd-highspeed;
- sd-uhs-sdr25;
+ sd-uhs-sdr50;
+ sd-uhs-sdr104;
cd-gpios = <&pio 132 0>;
vmmc-supply = <&mt6397_vmch_reg>;
vqmmc-supply = <&mt6397_vmc_reg>;
@@ -154,13 +159,19 @@
<MT8173_PIN_64_MSDC0_DAT7__FUNC_MSDC0_DAT7>,
<MT8173_PIN_66_MSDC0_CMD__FUNC_MSDC0_CMD>;
input-enable;
- drive-strength = <MTK_DRIVE_2mA>;
+ drive-strength = <MTK_DRIVE_4mA>;
bias-pull-up = <MTK_PUPD_SET_R1R0_01>;
};
pins_clk {
pinmux = <MT8173_PIN_65_MSDC0_CLK__FUNC_MSDC0_CLK>;
- drive-strength = <MTK_DRIVE_2mA>;
+ drive-strength = <MTK_DRIVE_4mA>;
+ bias-pull-down = <MTK_PUPD_SET_R1R0_01>;
+ };
+
+ pins_ds {
+ pinmux = <MT8173_PIN_67_MSDC0_DSL__FUNC_MSDC0_DSL>;
+ drive-strength = <MTK_DRIVE_6mA>;
bias-pull-down = <MTK_PUPD_SET_R1R0_01>;
};
@@ -450,8 +450,9 @@
reg = <0 0x11230000 0 0x1000>;
interrupts = <GIC_SPI 71 IRQ_TYPE_LEVEL_LOW>;
clocks = <&pericfg CLK_PERI_MSDC30_0>,
- <&topckgen CLK_TOP_MSDC50_0_H_SEL>;
- clock-names = "source", "hclk";
+ <&topckgen CLK_TOP_MSDC50_0_H_SEL>,
+ <&topckgen CLK_TOP_MSDCPLL_D2>;
+ clock-names = "source", "hclk", "400mhz";
status = "disabled";
};
Add HS200/HS400 support for EMMC Add SDR50/SDR104 support for SD Add 400Mhz source clock Signed-off-by: Chaotian Jing <chaotian.jing@mediatek.com> --- arch/arm64/boot/dts/mediatek/mt8173-evb.dts | 21 ++++++++++++++++----- arch/arm64/boot/dts/mediatek/mt8173.dtsi | 5 +++-- 2 files changed, 19 insertions(+), 7 deletions(-)