@@ -315,17 +315,23 @@ static void mtk_iommu_config(struct mtk_iommu_data *data,
struct device *dev, bool enable)
{
struct mtk_smi_larb_iommu *larb_mmu;
- unsigned int larbid, portid;
+ unsigned int larbid, portid, domid;
struct iommu_fwspec *fwspec = dev_iommu_fwspec_get(dev);
+ const struct mtk_iommu_iova_region *region;
int i;
for (i = 0; i < fwspec->num_ids; ++i) {
larbid = MTK_M4U_TO_LARB(fwspec->ids[i]);
portid = MTK_M4U_TO_PORT(fwspec->ids[i]);
+ domid = MTK_M4U_TO_DOM(fwspec->ids[i]);
+
larb_mmu = &data->larb_imu[larbid];
+ region = data->plat_data->iova_region + domid;
+ larb_mmu->bank[portid] = upper_32_bits(region->iova_base);
- dev_dbg(dev, "%s iommu port: %d\n",
- enable ? "enable" : "disable", portid);
+ dev_dbg(dev, "%s iommu for larb(%s) port %d dom %d bank %d.\n",
+ enable ? "enable" : "disable", dev_name(larb_mmu->dev),
+ portid, domid, larb_mmu->bank[portid]);
if (enable)
larb_mmu->mmu |= MTK_SMI_MMU_EN(portid);
@@ -41,6 +41,8 @@
/* mt2712 */
#define SMI_LARB_NONSEC_CON(id) (0x380 + ((id) * 4))
#define F_MMU_EN BIT(0)
+#define BANK_SEL(a) ((((a) & 0x3) << 8) | (((a) & 0x3) << 10) |\
+ (((a) & 0x3) << 12) | (((a) & 0x3) << 14))
/* SMI COMMON */
#define SMI_BUS_SEL 0x220
@@ -85,6 +87,7 @@ struct mtk_smi_larb { /* larb: local arbiter */
const struct mtk_smi_larb_gen *larb_gen;
int larbid;
u32 *mmu;
+ unsigned char *bank;
};
static int mtk_smi_clk_enable(const struct mtk_smi *smi)
@@ -151,6 +154,7 @@ mtk_smi_larb_bind(struct device *dev, struct device *master, void *data)
if (dev == larb_mmu[i].dev) {
larb->larbid = i;
larb->mmu = &larb_mmu[i].mmu;
+ larb->bank = larb_mmu[i].bank;
return 0;
}
}
@@ -169,6 +173,7 @@ static void mtk_smi_larb_config_port_gen2_general(struct device *dev)
for_each_set_bit(i, (unsigned long *)larb->mmu, 32) {
reg = readl_relaxed(larb->base + SMI_LARB_NONSEC_CON(i));
reg |= F_MMU_EN;
+ reg |= BANK_SEL(larb->bank[i]);
writel(reg, larb->base + SMI_LARB_NONSEC_CON(i));
}
}
@@ -16,6 +16,7 @@
struct mtk_smi_larb_iommu {
struct device *dev;
unsigned int mmu;
+ unsigned char bank[32];
};
/*
After extending v7s, our pagetable already support iova reach 16GB(34bit). the master got the iova via dma_alloc_attrs may reach 34bits, but its HW register still is 32bit. then how to set the bit32/bit33 iova? this depend on a SMI larb setting(bank_sel). we separate whole 16GB iova to four banks: bank: 0: 0~4G; 1: 4~8G; 2: 8-12G; 3: 12-16G; The bank number is (iova >> 32). We will preassign which bank the larbs belong to. currently we don't have a interface for master to adjust its bank number. Each a bank is a iova_region which is a independent iommu-domain. the iova range for each iommu-domain can't cross 4G. Signed-off-by: Yong Wu <yong.wu@mediatek.com> --- drivers/iommu/mtk_iommu.c | 12 +++++++++--- drivers/memory/mtk-smi.c | 5 +++++ include/soc/mediatek/smi.h | 1 + 3 files changed, 15 insertions(+), 3 deletions(-)