@@ -123,6 +123,8 @@ struct mtk_iommu_domain {
static const struct iommu_ops mtk_iommu_ops;
+#define MTK_IOMMU_ADDR(addr) (lower_32_bits(addr) | upper_32_bits(addr))
+
/*
* In M4U 4GB mode, the physical address is remapped as below:
*
@@ -225,8 +227,9 @@ static void mtk_iommu_tlb_flush_range_sync(unsigned long iova, size_t size,
writel_relaxed(F_INVLD_EN1 | F_INVLD_EN0,
data->base + data->plat_data->inv_sel_reg);
- writel_relaxed(iova, data->base + REG_MMU_INVLD_START_A);
- writel_relaxed(iova + size - 1,
+ writel_relaxed(MTK_IOMMU_ADDR(iova),
+ data->base + REG_MMU_INVLD_START_A);
+ writel_relaxed(MTK_IOMMU_ADDR(iova + size - 1),
data->base + REG_MMU_INVLD_END_A);
writel_relaxed(F_MMU_INV_RANGE,
data->base + REG_MMU_INVALIDATE);
@@ -653,8 +656,7 @@ static int mtk_iommu_hw_init(const struct mtk_iommu_data *data)
if (data->plat_data->m4u_plat == M4U_MT8173)
regval = (data->protect_base >> 1) | (data->enable_4GB << 31);
else
- regval = lower_32_bits(data->protect_base) |
- upper_32_bits(data->protect_base);
+ regval = MTK_IOMMU_ADDR(data->protect_base);
writel_relaxed(regval, data->base + REG_MMU_IVRP_PADDR);
if (data->enable_4GB &&
If the iova is 34bit, the iova[32][33] is the bit0/1 in the tlb flush register. Add a new macro for this. there is a minor change unrelated with this patch. it also use the new macro. Signed-off-by: Yong Wu <yong.wu@mediatek.com> --- drivers/iommu/mtk_iommu.c | 10 ++++++---- 1 file changed, 6 insertions(+), 4 deletions(-)