@@ -118,7 +118,7 @@
};
&pca9654 {
- pcie_sata_switch {
+ pcie-sata-switch-hog {
gpio-hog;
gpios = <7 GPIO_ACTIVE_HIGH>;
output-low; /* enable SATA by default */
@@ -55,7 +55,7 @@
};
&pca9654 {
- pcie_sata_switch {
+ pcie-sata-switch-hog {
gpio-hog;
gpios = <7 GPIO_ACTIVE_HIGH>;
output-low; /* enable SATA by default */
@@ -143,49 +143,49 @@
interrupt-parent = <&gpio6>;
interrupts = <8 IRQ_TYPE_EDGE_FALLING>;
- audio_out_off {
+ audio-out-off-hog {
gpio-hog;
gpios = <0 GPIO_ACTIVE_HIGH>; /* P00 */
output-high;
line-name = "Audio_Out_OFF";
};
- hub_pwen {
+ hub-pwen-hog {
gpio-hog;
gpios = <6 GPIO_ACTIVE_HIGH>;
output-high;
line-name = "HUB pwen";
};
- hub_rst {
+ hub-rst-hog {
gpio-hog;
gpios = <7 GPIO_ACTIVE_HIGH>;
output-high;
line-name = "HUB rst";
};
- otg_extlpn {
+ otg-extlpn-hog {
gpio-hog;
gpios = <9 GPIO_ACTIVE_HIGH>;
output-high;
line-name = "OTG EXTLPn";
};
- otg_offvbusn {
+ otg-offvbusn-hog {
gpio-hog;
gpios = <8 GPIO_ACTIVE_HIGH>;
output-low;
line-name = "OTG OFFVBUSn";
};
- sd-wifi-mux {
+ sd-wifi-mux-hog {
gpio-hog;
gpios = <5 GPIO_ACTIVE_HIGH>;
output-low; /* Connect WL1837 */
line-name = "SD WiFi mux";
};
- snd_rst {
+ snd-rst-hog {
gpio-hog;
gpios = <15 GPIO_ACTIVE_HIGH>; /* P17 */
output-high;
The convention for node names is to use hyphens, not underscores. dtschema for pca95xx expects GPIO hogs to end with 'hog' prefix. Signed-off-by: Krzysztof Kozlowski <krzk@kernel.org> --- .../boot/dts/renesas/r8a77951-salvator-xs.dts | 2 +- .../boot/dts/renesas/r8a77965-salvator-xs.dts | 2 +- arch/arm64/boot/dts/renesas/ulcb-kf.dtsi | 14 +++++++------- 3 files changed, 9 insertions(+), 9 deletions(-)