@@ -493,12 +493,6 @@ mt7530_setup_port6(struct dsa_switch *ds, phy_interface_t interface)
return 0;
}
-static int
-mt7530_pad_clk_setup(struct dsa_switch *ds, phy_interface_t interface)
-{
- return 0;
-}
-
static bool mt7531_dual_sgmii_supported(struct mt7530_priv *priv)
{
u32 val;
@@ -508,12 +502,6 @@ static bool mt7531_dual_sgmii_supported(struct mt7530_priv *priv)
return (val & PAD_DUAL_SGMII_EN) != 0;
}
-static int
-mt7531_pad_setup(struct dsa_switch *ds, phy_interface_t interface)
-{
- return 0;
-}
-
static void
mt7531_pll_setup(struct mt7530_priv *priv)
{
@@ -2516,14 +2504,6 @@ static void mt7531_mac_port_get_caps(struct dsa_switch *ds, int port,
}
}
-static int
-mt753x_pad_setup(struct dsa_switch *ds, const struct phylink_link_state *state)
-{
- struct mt7530_priv *priv = ds->priv;
-
- return priv->info->pad_setup(ds, state->interface);
-}
-
static int
mt7530_mac_config(struct dsa_switch *ds, int port, unsigned int mode,
phy_interface_t interface)
@@ -2798,8 +2778,6 @@ mt753x_phylink_mac_config(struct dsa_switch *ds, int port, unsigned int mode,
if (priv->p6_interface == state->interface)
break;
- mt753x_pad_setup(ds, state);
-
if (mt753x_mac_config(ds, port, mode, state) < 0)
goto unsupported;
@@ -3215,7 +3193,6 @@ static const struct mt753x_info mt753x_table[] = {
.phy_write_c22 = mt7530_phy_write_c22,
.phy_read_c45 = mt7530_phy_read_c45,
.phy_write_c45 = mt7530_phy_write_c45,
- .pad_setup = mt7530_pad_clk_setup,
.mac_port_get_caps = mt7530_mac_port_get_caps,
.mac_port_config = mt7530_mac_config,
},
@@ -3227,7 +3204,6 @@ static const struct mt753x_info mt753x_table[] = {
.phy_write_c22 = mt7530_phy_write_c22,
.phy_read_c45 = mt7530_phy_read_c45,
.phy_write_c45 = mt7530_phy_write_c45,
- .pad_setup = mt7530_pad_clk_setup,
.mac_port_get_caps = mt7530_mac_port_get_caps,
.mac_port_config = mt7530_mac_config,
},
@@ -3239,7 +3215,6 @@ static const struct mt753x_info mt753x_table[] = {
.phy_write_c22 = mt7531_ind_c22_phy_write,
.phy_read_c45 = mt7531_ind_c45_phy_read,
.phy_write_c45 = mt7531_ind_c45_phy_write,
- .pad_setup = mt7531_pad_setup,
.cpu_port_config = mt7531_cpu_port_config,
.mac_port_get_caps = mt7531_mac_port_get_caps,
.mac_port_config = mt7531_mac_config,
@@ -3297,9 +3272,8 @@ mt7530_probe(struct mdio_device *mdiodev)
/* Sanity check if these required device operations are filled
* properly.
*/
- if (!priv->info->sw_setup || !priv->info->pad_setup ||
- !priv->info->phy_read_c22 || !priv->info->phy_write_c22 ||
- !priv->info->mac_port_get_caps ||
+ if (!priv->info->sw_setup || !priv->info->phy_read_c22 ||
+ !priv->info->phy_write_c22 || !priv->info->mac_port_get_caps ||
!priv->info->mac_port_config)
return -EINVAL;
@@ -754,8 +754,6 @@ struct mt753x_pcs {
* @phy_write_c22: Holding the way writing PHY port using C22
* @phy_read_c45: Holding the way reading PHY port using C45
* @phy_write_c45: Holding the way writing PHY port using C45
- * @pad_setup: Holding the way setting up the bus pad for a certain
- * MAC port
* @phy_mode_supported: Check if the PHY type is being supported on a certain
* port
* @mac_port_validate: Holding the way to set addition validate type for a
@@ -776,7 +774,6 @@ struct mt753x_info {
int regnum);
int (*phy_write_c45)(struct mt7530_priv *priv, int port, int devad,
int regnum, u16 val);
- int (*pad_setup)(struct dsa_switch *ds, phy_interface_t interface);
int (*cpu_port_config)(struct dsa_switch *ds, int port);
void (*mac_port_get_caps)(struct dsa_switch *ds, int port,
struct phylink_config *config);