diff mbox series

[net-next,11/15] net: dsa: mt7530: move XTAL check to mt7530_setup()

Message ID 20231118131317.295591-1-arinc.unal@arinc9.com (mailing list archive)
State New, archived
Headers show
Series MT7530 DSA subdriver improvements | expand

Commit Message

Arınç ÜNAL Nov. 18, 2023, 1:13 p.m. UTC 
The crystal frequency concerns the switch core. The frequency should be
checked when the switch is being set up so the driver can reject the
unsupported hardware earlier and without requiring port 6 to be used.

Move it to mt7530_setup(). Drop the unnecessary function printing.

Signed-off-by: Arınç ÜNAL <arinc.unal@arinc9.com>
Reviewed-by: Andrew Lunn <andrew@lunn.ch>
---
 drivers/net/dsa/mt7530.c | 13 ++++++-------
 1 file changed, 6 insertions(+), 7 deletions(-)
diff mbox series

Patch

diff --git a/drivers/net/dsa/mt7530.c b/drivers/net/dsa/mt7530.c
index efe5ffe3455d..167b340350b3 100644
--- a/drivers/net/dsa/mt7530.c
+++ b/drivers/net/dsa/mt7530.c
@@ -422,13 +422,6 @@  mt7530_setup_port6(struct dsa_switch *ds, phy_interface_t interface)
 
 	xtal = mt7530_read(priv, MT7530_MHWTRAP) & HWTRAP_XTAL_MASK;
 
-	if (xtal == HWTRAP_XTAL_20MHZ) {
-		dev_err(priv->dev,
-			"%s: MT7530 with a 20MHz XTAL is not supported!\n",
-			__func__);
-		return -EINVAL;
-	}
-
 	switch (interface) {
 	case PHY_INTERFACE_MODE_RGMII:
 		trgint = 0;
@@ -2235,6 +2228,12 @@  mt7530_setup(struct dsa_switch *ds)
 		return -ENODEV;
 	}
 
+	if ((val & HWTRAP_XTAL_MASK) == HWTRAP_XTAL_20MHZ) {
+		dev_err(priv->dev,
+			"MT7530 with a 20MHz XTAL is not supported!\n");
+		return -EINVAL;
+	}
+
 	/* Reset the switch through internal reset */
 	mt7530_write(priv, MT7530_SYS_CTRL,
 		     SYS_CTRL_PHY_RST | SYS_CTRL_SW_RST |