new file mode 100644
@@ -0,0 +1,75 @@
+# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
+%YAML 1.2
+---
+$id: "http://devicetree.org/schemas/interrupt-controller/loongson,ls3-iointc.yaml#"
+$schema: "http://devicetree.org/meta-schemas/core.yaml#"
+
+title: Loongson-3 I/O Interrupt Controller
+
+maintainers:
+ - Jiaxun Yang <jiaxun.yang@flygoat.com>
+
+description: |
+ This interrupt controller is found in the Loongson-3 family of chips as the primary
+ package interrupt source which can route interrupt to interrupt line of cores.
+
+properties:
+ compatible:
+ const: loongson,ls3-iointc
+
+ reg:
+ maxItems: 1
+
+
+ interrupt-controller: true
+
+ "#interrupt-cells":
+ description: |
+ Specifies the number of cells needed to encode an interrupt source.
+ Must be 2 or 4.
+ If the system requires describing interrupt line & core mapping, than
+ it must be 4.
+
+ The 1st cell is the hardware interrupt number.
+
+ The 2nd cell is the flags, encoded as follows:
+ bits[3:0] trigger type and level flags.
+ 1 = low-to-high edge triggered
+ 2 = high-to-low edge triggered
+ 4 = active high level-sensitive
+ 8 = active low level-sensitive.
+
+ The 3rd is the parent interrupt line that interrupt would map to.
+ As the CPU preserved 4 interrupt lines for I/O, in theory any of the iointc
+ interrupt can be chained to any interrupt lines on a core. But currently
+ we can only map all the interrupt to a single parent, so this cell must be
+ set uniformly for all the child interrupts corresponding to the parent
+ interrupt.
+
+ The 4th is the parent core that interrupt would map to. The interrupt
+ contoller can map any of the interrupt to the specified core on a package.
+ This cell determined the core. It must be the bootcore.
+
+ If the 3rd, 4th cell is not set, it will default to the 0# interrupt line
+ and bootcore.
+
+ enum: [ 2, 4 ]
+
+required:
+ - compatible
+ - reg
+ - interrupts
+ - interrupt-controller
+ - '#interrupt-cells'
+
+
+examples:
+ - |
+ iointc: interrupt-controller@3ff01400 {
+ compatible = "loongson,ls3-io-intc";
+ reg = <0x3ff01400 0x60>;
+ interrupts = <2>;
+ interrupt-controller;
+ #interrupt-cells = <4>;
+ };
+...
Document Loongson-3 I/O Interrupt controller. Signed-off-by: Jiaxun Yang <jiaxun.yang@flygoat.com> --- .../loongson,ls3-iointc.yaml | 75 +++++++++++++++++++ 1 file changed, 75 insertions(+) create mode 100644 Documentation/devicetree/bindings/interrupt-controller/loongson,ls3-iointc.yaml