@@ -68,6 +68,15 @@ config MMC_SDHCI_PCI
If unsure, say N.
+config MMC_SDHCI_AUTO_CMD23
+ tristate "SDHCI 3.0 Auto-CMD23 support (EXPERIMENTAL)"
+ depends on MMC_SDHCI && EXPERIMENTAL
+ help
+ This enables the Auto-CMD23 optimization for multiblock
+ transfers where a CMD23 would be sent
+
+ If unsure, say N.
+
config MMC_RICOH_MMC
bool "Ricoh MMC Controller Disabler (EXPERIMENTAL)"
depends on MMC_SDHCI_PCI
@@ -844,7 +844,13 @@ static void sdhci_set_transfer_mode(struct sdhci_host *host,
if (!host->mrq->sbc &&
host->flags & SDHCI_ACMD12)
mode |= SDHCI_TRNS_ACMD12;
+ else if (host->mrq->sbc &&
+ host->flags & SDHCI_ACMD23) {
+ mode |= SDHCI_TRNS_ACMD23;
+ sdhci_writel(host, data->blocks, SDHCI_ARGUMENT2);
+ }
}
+
if (data->flags & MMC_DATA_READ)
mode |= SDHCI_TRNS_READ;
if (host->flags & SDHCI_REQ_USE_DMA)
@@ -1189,7 +1195,7 @@ static void sdhci_request(struct mmc_host *mmc, struct mmc_request *mrq)
tasklet_schedule(&host->finish_tasklet);
} else {
- if (mrq->sbc)
+ if (mrq->sbc && !(host->flags & SDHCI_ACMD23))
sdhci_send_command(host, mrq->sbc);
else
sdhci_send_command(host, mrq->cmd);
@@ -1947,6 +1953,14 @@ int sdhci_add_host(struct sdhci_host *host)
if (host->quirks & SDHCI_QUIRK_MULTIBLOCK_READ_ACMD12)
host->flags |= SDHCI_ACMD12;
+#ifdef CONFIG_MMC_SDHCI_CMD23
+ /* Auto-CMD23 stuff only works in ADMA or PIO. */
+ if ((host->version == SDHCI_SPEC_300) &&
+ ((host->flags & SDHCI_USE_ADMA) ||
+ !(host->flags & SDHCI_REQ_USE_DMA)))
+ host->flags |= SDHCI_ACMD23;
+#endif
+
/*
* A controller may support 8-bit width, but the board itself
* might not have the pins brought out. Boards that support
@@ -25,6 +25,7 @@
*/
#define SDHCI_DMA_ADDRESS 0x00
+#define SDHCI_ARGUMENT2 0x00
#define SDHCI_BLOCK_SIZE 0x04
#define SDHCI_MAKE_BLKSZ(dma, blksz) (((dma & 0x7) << 12) | (blksz & 0xFFF))
@@ -37,6 +38,7 @@
#define SDHCI_TRNS_DMA 0x01
#define SDHCI_TRNS_BLK_CNT_EN 0x02
#define SDHCI_TRNS_ACMD12 0x04
+#define SDHCI_TRNS_ACMD23 0x08
#define SDHCI_TRNS_READ 0x10
#define SDHCI_TRNS_MULTI 0x20
@@ -110,6 +110,7 @@ struct sdhci_host {
#define SDHCI_REQ_USE_DMA (1<<2) /* Use DMA for this req. */
#define SDHCI_DEVICE_DEAD (1<<3) /* Device unresponsive */
#define SDHCI_ACMD12 (1<<4) /* Auto CMD12 support */
+#define SDHCI_ACMD23 (1<<5) /* Auto CMD23 support */
unsigned int version; /* SDHCI spec. version */
Enables Auto-CMD23 support where available (SDHCI 3.0 controllers) Cc: arindam.nath@amd.com Cc: cjb@laptop.org Cc: arnd@arndb.de Cc: subhashj@codeaurora.org Signed-off-by: Andrei Warkentin <andreiw@motorola.com> --- drivers/mmc/host/Kconfig | 9 +++++++++ drivers/mmc/host/sdhci.c | 16 +++++++++++++++- drivers/mmc/host/sdhci.h | 2 ++ include/linux/mmc/sdhci.h | 1 + 4 files changed, 27 insertions(+), 1 deletions(-)