diff mbox

[v2,4/6] mmc: tmio: add eMMC support

Message ID 20160919124921.8172-5-wsa+renesas@sang-engineering.com (mailing list archive)
State New, archived
Headers show

Commit Message

Wolfram Sang Sept. 19, 2016, 12:49 p.m. UTC
We need to add R1 without CRC support, refactor the bus width routine a
little and extend a quirk check. To support "non-removable;" we need a
workaround which will be hopefully removed when reworking PM soon.

Signed-off-by: Wolfram Sang <wsa+renesas@sang-engineering.com>
---
 drivers/mmc/host/tmio_mmc.h     |  3 +++
 drivers/mmc/host/tmio_mmc_pio.c | 38 ++++++++++++++++++++++++++------------
 2 files changed, 29 insertions(+), 12 deletions(-)

Comments

Sergei Shtylyov Sept. 19, 2016, 5:31 p.m. UTC | #1
Hello.

On 09/19/2016 03:49 PM, Wolfram Sang wrote:

> We need to add R1 without CRC support, refactor the bus width routine a
> little and extend a quirk check. To support "non-removable;" we need a
> workaround which will be hopefully removed when reworking PM soon.
>
> Signed-off-by: Wolfram Sang <wsa+renesas@sang-engineering.com>
> ---
>  drivers/mmc/host/tmio_mmc.h     |  3 +++
>  drivers/mmc/host/tmio_mmc_pio.c | 38 ++++++++++++++++++++++++++------------
>  2 files changed, 29 insertions(+), 12 deletions(-)
>
> diff --git a/drivers/mmc/host/tmio_mmc.h b/drivers/mmc/host/tmio_mmc.h
> index 4b501f2d529f6e..637581faf756b1 100644
> --- a/drivers/mmc/host/tmio_mmc.h
> +++ b/drivers/mmc/host/tmio_mmc.h
> @@ -79,6 +79,9 @@
>  #define	CLK_CTL_DIV_MASK	0xff
>  #define	CLK_CTL_SCLKEN		BIT(8)
>
> +#define CARD_OPT_WIDTH8		BIT(13)
> +#define CARD_OPT_WIDTH		BIT(15)
> +
>  #define TMIO_BBS		512		/* Boot block size */
>
>  /* Definitions for values the CTRL_SDIO_STATUS register can take. */
> diff --git a/drivers/mmc/host/tmio_mmc_pio.c b/drivers/mmc/host/tmio_mmc_pio.c
> index 46b5a456243b84..a0f05eb4f34490 100644
> --- a/drivers/mmc/host/tmio_mmc_pio.c
> +++ b/drivers/mmc/host/tmio_mmc_pio.c
[...]
> @@ -922,14 +925,16 @@ static void tmio_mmc_power_off(struct tmio_mmc_host *host)
>  static void tmio_mmc_set_bus_width(struct tmio_mmc_host *host,
>  				unsigned char bus_width)
>  {
> -	switch (bus_width) {
> -	case MMC_BUS_WIDTH_1:
> -		sd_ctrl_write16(host, CTL_SD_MEM_CARD_OPT, 0x80e0);
> -		break;
> -	case MMC_BUS_WIDTH_4:
> -		sd_ctrl_write16(host, CTL_SD_MEM_CARD_OPT, 0x00e0);
> -		break;
> -	}
> +	u16 reg = sd_ctrl_read16(host, CTL_SD_MEM_CARD_OPT)
> +				& ~(CARD_OPT_WIDTH | CARD_OPT_WIDTH8);
> +
> +	/* reg now applies to MMC_BUS_WIDTH_4 */
> +	if (bus_width == MMC_BUS_WIDTH_1)
> +		reg |= CARD_OPT_WIDTH;
> +	else if (bus_width == MMC_BUS_WIDTH_8)
> +		reg |= CARD_OPT_WIDTH8;

    Why not *switch*?

[...]

MBR, Sergei

--
To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Wolfram Sang Sept. 19, 2016, 8:26 p.m. UTC | #2
> >+	u16 reg = sd_ctrl_read16(host, CTL_SD_MEM_CARD_OPT)
> >+				& ~(CARD_OPT_WIDTH | CARD_OPT_WIDTH8);
> >+
> >+	/* reg now applies to MMC_BUS_WIDTH_4 */
> >+	if (bus_width == MMC_BUS_WIDTH_1)
> >+		reg |= CARD_OPT_WIDTH;
> >+	else if (bus_width == MMC_BUS_WIDTH_8)
> >+		reg |= CARD_OPT_WIDTH8;
> 
>    Why not *switch*?

Didn't look better to me.
diff mbox

Patch

diff --git a/drivers/mmc/host/tmio_mmc.h b/drivers/mmc/host/tmio_mmc.h
index 4b501f2d529f6e..637581faf756b1 100644
--- a/drivers/mmc/host/tmio_mmc.h
+++ b/drivers/mmc/host/tmio_mmc.h
@@ -79,6 +79,9 @@ 
 #define	CLK_CTL_DIV_MASK	0xff
 #define	CLK_CTL_SCLKEN		BIT(8)
 
+#define CARD_OPT_WIDTH8		BIT(13)
+#define CARD_OPT_WIDTH		BIT(15)
+
 #define TMIO_BBS		512		/* Boot block size */
 
 /* Definitions for values the CTRL_SDIO_STATUS register can take. */
diff --git a/drivers/mmc/host/tmio_mmc_pio.c b/drivers/mmc/host/tmio_mmc_pio.c
index 46b5a456243b84..a0f05eb4f34490 100644
--- a/drivers/mmc/host/tmio_mmc_pio.c
+++ b/drivers/mmc/host/tmio_mmc_pio.c
@@ -340,7 +340,9 @@  static int tmio_mmc_start_command(struct tmio_mmc_host *host, struct mmc_command
 
 	switch (mmc_resp_type(cmd)) {
 	case MMC_RSP_NONE: c |= RESP_NONE; break;
-	case MMC_RSP_R1:   c |= RESP_R1;   break;
+	case MMC_RSP_R1:
+	case MMC_RSP_R1_NO_CRC:
+			   c |= RESP_R1;   break;
 	case MMC_RSP_R1B:  c |= RESP_R1B;  break;
 	case MMC_RSP_R2:   c |= RESP_R2;   break;
 	case MMC_RSP_R3:   c |= RESP_R3;   break;
@@ -737,12 +739,13 @@  static int tmio_mmc_start_data(struct tmio_mmc_host *host,
 	pr_debug("setup data transfer: blocksize %08x  nr_blocks %d\n",
 		 data->blksz, data->blocks);
 
-	/* Some hardware cannot perform 2 byte requests in 4 bit mode */
-	if (host->mmc->ios.bus_width == MMC_BUS_WIDTH_4) {
+	/* Some hardware cannot perform 2 byte requests in 4/8 bit mode */
+	if (host->mmc->ios.bus_width == MMC_BUS_WIDTH_4 ||
+	    host->mmc->ios.bus_width == MMC_BUS_WIDTH_8) {
 		int blksz_2bytes = pdata->flags & TMIO_MMC_BLKSZ_2BYTES;
 
 		if (data->blksz < 2 || (data->blksz < 4 && !blksz_2bytes)) {
-			pr_err("%s: %d byte block unsupported in 4 bit mode\n",
+			pr_err("%s: %d byte block unsupported in 4/8 bit mode\n",
 			       mmc_hostname(host->mmc), data->blksz);
 			return -EINVAL;
 		}
@@ -922,14 +925,16 @@  static void tmio_mmc_power_off(struct tmio_mmc_host *host)
 static void tmio_mmc_set_bus_width(struct tmio_mmc_host *host,
 				unsigned char bus_width)
 {
-	switch (bus_width) {
-	case MMC_BUS_WIDTH_1:
-		sd_ctrl_write16(host, CTL_SD_MEM_CARD_OPT, 0x80e0);
-		break;
-	case MMC_BUS_WIDTH_4:
-		sd_ctrl_write16(host, CTL_SD_MEM_CARD_OPT, 0x00e0);
-		break;
-	}
+	u16 reg = sd_ctrl_read16(host, CTL_SD_MEM_CARD_OPT)
+				& ~(CARD_OPT_WIDTH | CARD_OPT_WIDTH8);
+
+	/* reg now applies to MMC_BUS_WIDTH_4 */
+	if (bus_width == MMC_BUS_WIDTH_1)
+		reg |= CARD_OPT_WIDTH;
+	else if (bus_width == MMC_BUS_WIDTH_8)
+		reg |= CARD_OPT_WIDTH8;
+
+	sd_ctrl_write16(host, CTL_SD_MEM_CARD_OPT, reg);
 }
 
 /* Set MMC clock / power.
@@ -1149,6 +1154,15 @@  int tmio_mmc_host_probe(struct tmio_mmc_host *_host,
 				  !mmc_card_is_removable(mmc) ||
 				  mmc->slot.cd_irq >= 0);
 
+	/*
+	 * On Gen2+, eMMC with NONREMOVABLE currently fails because native
+	 * hotplug gets disabled. It seems RuntimePM related yet we need further
+	 * research. Since we are planning a PM overhaul anyway, let's enforce
+	 * for now the device being active by enabling native hotplug always.
+	 */
+	if (pdata->flags & TMIO_MMC_MIN_RCAR2)
+		_host->native_hotplug = true;
+
 	if (tmio_mmc_clk_enable(_host) < 0) {
 		mmc->f_max = pdata->hclk;
 		mmc->f_min = mmc->f_max / 512;