diff mbox series

[1/4] dt-bindings: mmc: sdhci-am654: Document bindings for the host controllers on TI's J721E devices.

Message ID 20190604060914.10886-2-faiz_abbas@ti.com (mailing list archive)
State New, archived
Headers show
Series Add Support for MMC in J721E | expand

Commit Message

Faiz Abbas June 4, 2019, 6:09 a.m. UTC
Add binding documentation for mmc host controllers present on TI's J721E
SOC. The 4 bit IP on J721E doesn't have a phy DLL so make DLL related
properties as optional for that compatible. Also add an optional
strobe-sel property used for HS400 speed mode.

Signed-off-by: Faiz Abbas <faiz_abbas@ti.com>
---
 Documentation/devicetree/bindings/mmc/sdhci-am654.txt | 9 ++++++++-
 1 file changed, 8 insertions(+), 1 deletion(-)
diff mbox series

Patch

diff --git a/Documentation/devicetree/bindings/mmc/sdhci-am654.txt b/Documentation/devicetree/bindings/mmc/sdhci-am654.txt
index 15dbbbace27e..50e87df47971 100644
--- a/Documentation/devicetree/bindings/mmc/sdhci-am654.txt
+++ b/Documentation/devicetree/bindings/mmc/sdhci-am654.txt
@@ -8,7 +8,10 @@  Only deviations are documented here.
   [3] Documentation/devicetree/bindings/interrupt-controller/interrupts.txt
 
 Required Properties:
-	- compatible: should be "ti,am654-sdhci-5.1"
+	- compatible: should be one of:
+			"ti,am654-sdhci-5.1": SDHCI on AM654 device.
+			"ti,j721e-sdhci-8bit": 8 bit SDHCI on J721E device.
+			"ti,j721e-sdhci-4bit": 4 bit SDHCI on J721E device.
 	- reg: Must be two entries.
 		- The first should be the sdhci register space
 		- The second should the subsystem/phy register space
@@ -16,9 +19,13 @@  Required Properties:
 	- clock-names: Tuple including "clk_xin" and "clk_ahb"
 	- interrupts: Interrupt specifiers
 	- ti,otap-del-sel: Output Tap Delay select
+
+Optional Properties (Required for ti,am654-sdhci-5.1 and ti,j721e-sdhci-8bit):
 	- ti,trm-icp: DLL trim select
 	- ti,driver-strength-ohm: driver strength in ohms.
 				  Valid values are 33, 40, 50, 66 and 100 ohms.
+Optional Properties:
+	- ti,strobe-sel: strobe select delay for HS400 speed mode. Default value: 0x0.
 
 Example: