@@ -631,11 +631,20 @@ static bool renesas_sdhi_check_scc_error(struct tmio_mmc_host *host)
return renesas_sdhi_manual_correction(host, use_4tap);
}
-static void renesas_sdhi_hw_reset(struct tmio_mmc_host *host)
+static void renesas_sdhi_reset(struct tmio_mmc_host *host)
{
- struct renesas_sdhi *priv;
+ struct renesas_sdhi *priv = host_to_priv(host);
- priv = host_to_priv(host);
+ /* FIXME - should we set stop clock reg here */
+ sd_ctrl_write16(host, CTL_RESET_SD, 0x0000);
+ usleep_range(10000, 11000);
+ sd_ctrl_write16(host, CTL_RESET_SD, 0x0001);
+ usleep_range(10000, 11000);
+
+ if (host->pdata->flags & TMIO_MMC_SDIO_IRQ) {
+ sd_ctrl_write16(host, CTL_SDIO_IRQ_MASK, host->sdio_irq_mask);
+ sd_ctrl_write16(host, CTL_TRANSACTION_CTL, 0x0001);
+ }
renesas_sdhi_reset_scc(host, priv);
renesas_sdhi_reset_hs400_mode(host, priv);
@@ -862,11 +871,9 @@ int renesas_sdhi_probe(struct platform_device *pdev,
renesas_sdhi_start_signal_voltage_switch;
host->sdcard_irq_setbit_mask = TMIO_STAT_ALWAYS_SET_27;
- /* SDR and HS200/400 registers requires HW reset */
if (of_data && of_data->scc_offset) {
priv->scc_ctl = host->ctl + of_data->scc_offset;
- host->mmc->caps |= MMC_CAP_HW_RESET;
- host->hw_reset = renesas_sdhi_hw_reset;
+ host->reset = renesas_sdhi_reset;
}
}
This driver got the usage of 'hw_reset' wrong and missed that it is used to reset the remote HW (card) only, not the local one (controller). Move everything to the proper 'reset' callback. Also, add the generic reset code from TMIO, so we will ensure the same behaviour (it will get refactored away in a later patch). This also means we need to drop MMC_CAP_HW_RESET because this is currently not supported by our hardware. Signed-off-by: Wolfram Sang <wsa+renesas@sang-engineering.com> --- drivers/mmc/host/renesas_sdhi_core.c | 19 +++++++++++++------ 1 file changed, 13 insertions(+), 6 deletions(-)